Get matched with top toilet pros in Whetstone, AZ

The order of your bathroom renovation should prevent damage to the completed work. Start with demolition and removing the old fixtures. Then, address structural repairs or water damage, if needed. Next, tackle the rough-in phase for plumbing and electrical work, install waterproofing, and work on wall treatments like tile or paint. Install your shower or bathtub, toilet, vanity, and sink. Flooring goes in after major fixtures but before the toilet. Lastly, install new lighting fixtures, mirrors, and other finishing touches as desired.

According to the Uniform Plumbing Code (UPC), the distance between your trap and the vent should be no more than 6 feet. For your vent to work properly, it needs to feed into the drain line within 6 feet of trapways that connect to it. Using this formula, you should be able to determine whether you will need multiple vent lines.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

A standard toilet flange should fit snugly into the outflow pipe and sit level with the subfloor. Installing a new one without first removing the old one will make it impossible to form a seal and keep the toilet bowl bolted securely in place. 

However, if you’re dealing with leakage or wobbling because you’ve installed a new type of bathroom tile (making the floor taller), you may be able to avoid fully replacing the flange by opting for a toilet flange extender. Extenders typically come in kits for easy DIY installation, fit over the existing flange, and bring the drain connection higher.