Get matched with top bathtub restoration pros in Ajo, AZ

Reglazing a bathtub can last as few as three years and up to 15 years. With proper application, the recoated surface is as durable as a brand-new tub. Clean your tub properly and avoid using abrasive cleaners to maintain the coating. If the weather conditions were cold or humid during resurfacing or the tub was significantly damaged, the reglazing may not last as long.

You can use other ways to seal the space where your tub and the bathroom tile meet. Using sealant tape, epoxy sealer, and spray foam can be just as effective as caulking your bathtub. When using alternatives to caulk, the one that is best for you depends on your preferences. 

Sealant tape takes less time and effort to use, which is why some homeowners prefer it. Meanwhile, epoxy sealer creates a smooth and glossy finish that can complement your bathroom. Lastly, spray foam is waterproof and can act as insulation for your tub.

Two alternatives to reglazing are installing a bathtub inlay or a bathtub liner. An inlay is a low-priced mat that adheres to the bottom of a bathtub or shower. It’s useful for sealing minor leaks and concealing damage on the bottom of a tub. On the other hand, a bathtub liner is essentially a protective casing that goes over the entire tub. They are usually custom-fit and cost more than reglazing yet don’t last as long.

Bathtub refinishing costs an average of $460 and includes removing the finish, sanding or acid etching the surface, priming it, and applying an epoxy coating. After the coating cures, the bathtub should look as good as new, and the finish should last between seven and 10 years. Because bathtub refinishing requires hazardous chemicals, you should call a bathtub refinisher to do the job.