Get matched with top roofers in Nashville, AR

A spray foam roof lasts 20 to 30 years if installed and maintained correctly. Spray foam roofs should be recoated every 10 to 15 years to maintain the UV protection and waterproof surface of the foam material. The longevity of spray foam roofing will depend on the thickness and density of the foam, the protective coating, and how well it’s maintained.

During the framing process, builders connect the roof to the walls with materials, including metal connectors, plywood panels, and wood blocks. These roof-to-wall connections are important and provide weatherproofing, noise and temperature insulation, protection against pests, and home integrity. The type of connector and method used will vary, depending on your home’s construction and needs, and each has pros and cons in terms of cost, noise insulation, longevity, and reliability. Talk with your home or roofing contractor about the best connectors for your roof and walls, and what they recommend for your home.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Generally, roof flashing is installed under the shingles to create a watertight seal and prevent moisture from seeping in and causing damage. However, the exact placement can depend on the type of flashing. For instance, with step flashing, the shingles and flashing overlap each other, meaning the flashing is technically both over and under the shingles. Flashing also typically goes beneath the house siding and is often not visible from the ground.