Best water heater pros near De Queen, AR

When replacing an old unit, you might want to switch from a gas water heater to an electric water heater or vice versa. To do this, you will likely need to add infrastructure to the area. For example, you likely don’t have a gas line that served your old electric water heater. You’d have to call a plumber to put in a new gas line. If you’re replacing a gas unit with an electric one, the plumber will need to safely cap the old gas line. You will then need an electrician to add wiring for the new electric unit.

The chemicals in a water softener can wear down the anode rod in the heater and shorten its life span. However, for most people, the benefits of the softener outweigh this potential drawback.

Have a plumber inspect the anode rod annually for damage, as replacing the anode rod is far less expensive than replacing the entire water heater.

Yes, this would be an appropriate choice. In order to comply with the National Electric Code’s rules, you'll need to install a circuit breaker that's 125% larger than the intended load. In this case, you'll multiply 30 amps by 1.25 to find the necessary breaker size. Plugging that equation in for your 30-amp water heater will leave you with a 37.6-amp breaker. If your current water heater keeps tripping the breaker, it might be time to talk to a plumber or electrician about upgrading your water heater's setup.

Excessive pressure (above 80 psi) puts too much stress on plumbing pipes, joints, and fixtures. This can lead to leaks and burst pipes. Plus, it shortens the lifespan of appliances, can waste water, and can raise your utility bills. High water pressure might feel like a gift, but it’s actually a silent threat to plumbing.