Get matched with top masons in Eutaw, AL

The cost of masonry work varies widely depending on the type of masonry along with common cost factors like size, complexity, location, and season. Most exterior masonry work done in freezing temperatures tends to cost more because of the preparation and protection involved to keep the masonry from freezing before the mortar cures properly. The average price ranges per project or square foot for different types of masonry include:

• Brick wall (fence, garden wall, etc.): $10–$45 per square foot

• Natural stone wall: $40–$110 per square foot

• Manufactured stone veneer: $20–$40 per square foot

• Brick home exterior: $10–$30 per square foot

• Brick siding: $3–$10 per square foot

• Stone siding: $35–$50 per square foot

• Brick step replacement: $20–$30 per square foot

• Brick wall repair: $20–$40 per square foot

• Chimney repairs: $160–$750 per project

• Tuckpointing: $5–$25 per square foot

Mortar is a mixture of sand and cement that binds materials, such as bricks, stones, and concrete blocks, together. Think of it as the glue that fills in the gaps between bricks and stones, then seals them in place to prevent damage or deterioration. Mortar also helps spread the load across a wall or structure, keeping cracks and shifting at bay.

Yes, it is usually possible to repair a damaged brick mailbox. A professional brick mason or masonry contractor can perform the repairs. They can assess the damage, provide an estimate, and help you determine if the repair is worthwhile based on the mailbox's value and the extent of the damage. The repair process may involve sourcing replacement bricks and mortar. Damaged bricks can be cut out and replaced, or the mortar joints can be cut out and retucked. It's important to note that the new mortar may differ in color from the original. If the mailbox insert itself is damaged, it can typically be cut out and replaced as well. If your brick mailbox has been completely destroyed, you should check with your local building code enforcement office before rebuilding, as some areas do not allow brick mailboxes due to the potential hazard they pose to drivers.

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.