Get matched with top paving pros in Sistersville, WV

Building a road on a slope requires careful planning and will normally require a drainage system underneath to prevent flooding and damage to the road over time. Your professional may lengthen your road to create switchbacks if the slope directly to your home is too steep, as there are regulations for maximum road slope. The drainage system will help prevent runoff from the higher side of the slope from damaging the asphalt or concrete. Keep in mind that building a road on a slope isn’t a good DIY project, as a lot can go wrong.

Maintaining a driveway depends on the material your driveway is made of. Concrete and asphalt should be sealed to protect against water and freeze-thaw cycles. Cracks and expansion joints should be filled with a flexible polyurethane caulk or asphalt sealer. Before you apply a sealant to your driveway, consider pressure washing the surface. It will take off any loose sealant and any grime that might have caused a stain. Sealing over dirt and stains will trap it under the sealer.

If you live in colder climates, consider using sand rather than salt to de-ice. Sand helps melt the snow and ice without speeding up the freezing and unthawing process of your driveway, which helps prevent cracks from forming from the constant fluctuation of temperatures.

You should place a layer of thick landscaping fabric directly over the concrete slab and then a thin layer of leveling sand over that to protect the pavers from moisture. For border pavers, you should plan on locking them in place with polyurethane adhesive. This will prevent them from shifting under foot traffic.

In most cases, you don’t need a permit to repave your driveway, although some exceptions exist. If you’re widening your driveway and plan on widening the apron as well, you’ll usually need a permit from the Department of Transportation in your area. This permit costs between $50 and $300 in most cases. Most municipalities will also require a certified and insured contractor do the work relating to the apron and curb cut. You can contact your building department or ask your paving company if you need a permit. Your driveway professional will usually pull the permit for you.