Get matched with top roofers in Holmen, WI

Gaps between tiles are necessary to help with weatherproofing, allow for thermal expansion, and increase wind resistance. In general, a small gap no larger than 3 millimeters wide will encourage proper drainage and limit cracking. Beyond that, tiles should overlap a minimum of 3 inches, except at the eaves where they should extend to the center of the gutter.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.

Yes, hail damage to your roof can definitely cause water leaks in your roof. This is because hailstones can break, chip, crack, or split shingles of all types, exposing underlayment. This underlayment doesn’t offer as much protection against water, so when it becomes compromised, water can penetrate and leak deeper into your home.

Flapping shingles, or shingles that are lifting or curling away from your roof, can be glued back into place using roofing cement or sealant. Apply the glue underneath the shingle, then press it down firmly. You can leave a brick on top of the shingle to hold it in place overnight while the sealant dries.