Get matched with top roofers in Ettrick, WI

Generally, the term “rolled roofing” refers to MSR (mineral surface roll) roofing. This type of roofing is similar to asphalt shingles but comes in a roll that’s unraveled and installed over your roof deck. There are many types of rolled roofing, including TPO, EPDM, and modified bitumen roofing (aka torch down roofing).

Yes, roof ridge caps are a necessary part of your roof system. Your roof ridge cap is at the peak of your roof, where two slopes of your roof meet. Roof ridge caps seal the seam and help protect your roof from water and debris, and because they’re pre-bent and thicker, they’re more suited to the job than regular roof shingles, which can break when bent.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Manufacturers, insurance companies, and municipality regulations are phasing out three-tab shingles. Because of their short lifespan and lack of durability compared to other roofing material types, manufacturers are leaning toward better products, and cities and insurers are starting to require better building materials overall. However, 3-tab shingles are still for sale, and some roofing companies still install them.