Top-rated contractors.

Get matched with top contractors in Cassville, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Cassville, WI?

Select your specific project to find the pro for you.

Find Contractors in Cassville

Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Cassville, WI and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Major Home Repairs (General Contractor)

Serving Cassville, WI and surrounding areas

In business since 2006

Credit card accepted

"They did a good job. She had to submit like a photo but my daughter had them work on the central are of the loft. The deal was for one room. She got a lot of good ideal from her and it was worth it for her. They were professional and I did not hear anything negative."
Recommended by55%of homeowners
Avatar for Preferred Home Improvements
Preferred Home Improvements
4.7(
12
)
Major Home Repairs (General Contractor)

Serving Cassville, WI and surrounding areas

In business since 2010

Free estimates

Emergency services offered

"Dillon was a great guy and worked fast and efficient. My house is 50 plus years old and the duct work had never been cleaned. Post the work, the house even smelled better. I am in the middle of a complete remodel and living in the house. I had all 11 vent grilles removed -(saved Dillon a pile of time not having to remove and re-install) and I would have thought a discount would have been in order."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+30

Recommended by100%of homeowners
All In One
5.0(
4
)
Major Home Repairs (General Contractor)

Serving Cassville, WI and surrounding areas

In business since 2011

Free estimates

Credit card accepted

"My first experience on Angie's List was to find a contractor to repair a leaking roof.  When I purchase my home the roof had been replaced within 2 years of purchasing.  Yet within a year water was leaking into my living room.  When other contractors came out they'd stand in the driveway and look up at the roof, then tell me all I needed were new gutters, which didn't help. All in one actually got up on the roof to investigate determining where my roof was leaking and fix it. With their estimate they provided proof on insurance and state contractor certification.  Before the roof work commenced,  rain was forecast All In One, covered the roof with tarps.  Once the work was completed they cleaned up the yard and driveway of all the old tiles, nails, and other debris.  Shortly after they completed there work, it rained again.  I held my breath but no water came dripping down from the ceiling.  In addition to the roof, since they were going to be up on the roof, I had them replace an old skylight.  No, the skylight wasn't the cause of the leak, I just took advantage of the opportunity to replace it.
"
Recommended by100%of homeowners
Showing 1-10 of 17
Unfinished Carpentry questions, answered by experts

You should avoid drilling or cutting into load-bearing beams because removing material will weaken it and increase the risk of structural damage or even collapse. If you do need to drill into a load-bearing beam, speak with a structural engineer first to discuss where it’s safest to drill and the width and depth of the bit that’s safe to use.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

Professionals charge between $60 and $95 per hour to install ornamental porch columns. The amount of time they need varies based on the condition of the porch, whether they need to remove old columns, and if there is any damage to your porch's structure. This cost can increase if more issues come up during the installation process.

Yes, you can hang picture frames, shelves, and other items on Trusscore panels. For lightweight items (less than 30 pounds), the company recommends using adhesive strips rather than nails or screws. However, you’ll need to secure heavier objects to a stud in the wall. In these situations, Trusscore recommends cutting away the panel material and fastening the object to the stud with metal hardware.

Yes, ceiling joists are typically load-bearing. However, their primary function is to support the weight of the ceiling and loads applied to it, like lighting fixtures and ceiling fans. They can also help support the roof, especially if they’re part of truss systems. Remember, the load-bearing capacity of ceiling joists depends on the material, size, and space between them. 

The Cassville, WI homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.