Top-rated pool and spa technicians.

Best pool and spa technicians near Bloomer, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your pool and spa servicing project in Bloomer, WI?

Select your specific project to find the pro for you.

Top-Rated Pool and spa technicians in Bloomer - Updated Nov 2026

Pool and Spa Servicing FAQs, answered by experts

Yes, hot tubs can use a significant amount of electricity, primarily to keep the water heated. A typical hot tub uses between 1,500 and 6,000 watts, and the pump can add another 1,500 watts. This usage can result in a monthly cost of around $20 to $30. The exact amount of electricity consumed depends on several factors, including the hot tub's age, size, heater voltage (120V vs. 240V), usage habits, and thermostat setting. Newer, energy-efficient models generally use less power than older ones. To reduce electricity costs, consider investing in an energy-efficient model, using a quality insulated cover with a thermal blanket, and keeping the filters clean.

You can drain a hot tub very quickly by using a submersible pump rather than the hose-sized drain at the bottom exterior of the tub. A pump can move up to 30 gallons per minute, draining your hot tub in no time. Using the regular drain can take up to two hours.

Similar to a hot tub, swim spas last anywhere from five to 20 years, depending on quality and your attention to maintenance. The best way to increase the lifespan of your swim spa is to carefully maintain it—including draining it around every six months to deep clean the parts.

Shocking your hot tub means adding extra chemicals to the water. Most spa experts recommend doing this once a week for proper hot tub maintenance, but you can do it more if needed. Shocking has multiple benefits, including preventing the water from becoming murky and it’s essential in removing harmful bacteria from the water.

To refill a hot tub after winter, start by opening up the tub and giving it a quick cleaning. If you use antifreeze, drain out the water then grab a hose and thoroughly clean the tub shell out, spraying water into each jet of the tub. 

Reconnect the hot tub and turn the power back on. When it’s time to fill the tub again, insert the hose into the filter well (if available). Avoid trapping too much air in the water lines, which can cause the pump to lock up when it starts again. Add the necessary chemicals and start the heating process. It will take some time—most of a full day—for the water to heat up again.

The Bloomer, WI homeowners’ guide to pool and spa services

From average costs to expert advice, get all the answers you need to get your job done.