Top-rated pool and spa technicians.

Get matched with top pool and spa technicians in Augusta, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your pool and spa servicing project in Augusta, WI?

Select your specific project to find the pro for you.

Find Pool and spa technicians in Augusta

Pool and Spa Servicing questions, answered by experts

Vinegar can be used as an all-purpose cleaner for many things, including hot tub filters. Soaking hot tub filters in vinegar and water for up to 24 hours can remove dirt and oil, and as a bonus, it won’t cause the water to foam after you reinstall it if there’s vinegar left on it. But make sure you still rinse it to remove any debris, dirt, or grime stuck on it.

When your hot tub is completely dry, there is typically no need to introduce antifreeze into the plumbing. However, if you desire an extra layer of protection against potential freeze damage, you can consider adding some RV antifreeze to your hot tub lines. Just ensure that you use RV antifreeze specifically, as automotive antifreeze is highly toxic and should be avoided.

When your hot tub is not in use, you can keep it at a constant soaking temperature of around 100 degrees Fahrenheit. For extended periods of non-use, you can lower the temperature by about five degrees. This slight decrease makes it easier and quicker to heat back up to a desirable level when you're ready to use it again. Additionally, you might consider lowering the temperature by a couple of degrees during the summer to avoid feeling overheated.

Follow these general safety tips for spas and hot tubs:

  • Keep your exterior electrical receptacles covered and dry, especially around your hot tub and pool during periods of use.

  • Make sure you have a GFCI (ground fault circuit interrupter) properly installed to ensure no one gets accidentally shocked or injured by electrocution. 

  • Don’t use the hot tub or your pool during a thunderstorm. 

  • Before using the hot tub, have a certified electrician thoroughly inspect your hot tub and its wiring to make sure you’re in full compliance with all applicable local building codes. 

Yes, hot tubs can use a significant amount of electricity, primarily to keep the water heated. A typical hot tub uses between 1,500 and 6,000 watts, and the pump can add another 1,500 watts. This usage can result in a monthly cost of around $20 to $30. The exact amount of electricity consumed depends on several factors, including the hot tub's age, size, heater voltage (120V vs. 240V), usage habits, and thermostat setting. Newer, energy-efficient models generally use less power than older ones. To reduce electricity costs, consider investing in an energy-efficient model, using a quality insulated cover with a thermal blanket, and keeping the filters clean.

The Augusta, WI homeowners’ guide to pool and spa services

From average costs to expert advice, get all the answers you need to get your job done.