Top-rated pool and spa technicians.

Best pool and spa technicians near Bruce, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your pool and spa servicing project in Bruce, WI?

Select your specific project to find the pro for you.

Top-Rated Pool and spa technicians in Bruce - Updated Nov 2026

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Above Ground Swimming Pool or Accessories - Repair or ServiceHot Tub or Spa - Repair or ServiceIn Ground Swimming Pool or Accessories - Repair or Service+6 more

Serving Bruce, WI and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Pool and Spa Servicing FAQs, answered by experts

No, you cannot clean your hot tub filters in the dishwasher. While it may seem like a good idea, the dishwasher soap isn’t gentle enough for hot tub filters and can damage them. Gentle cleaning is better when cleaning the hot tub filters and keeping them intact.

If water is left inside the hot tub pump over a cold winter, it could freeze and severely damage the pump, water lines, and jets. That can cause leaks, which require very expensive repairs. Freezing or leftover water can stain and damage the hot tub shell, which leads to replacement. Even in mild climates, leaving sitting water in the tub or pipes for a long period of unuse is a bad idea, since disinfecting chemicals fade and the water can develop bacteria, algae, and other big headaches when it’s time to use the tub again.

Yes. If you test the water and the alkalinity is too low, you can raise it by adding an alkalinity increaser, which likely came with your hot tub’s chemical kit. In a pinch, you can use baking soda to raise the hot tub’s alkalinity. Raising the alkalinity will prevent the hot tub water from becoming too acidic.

How often you change the water in your swim spa depends on how often you use it. Most manufacturers recommend changing the water every three to six months. If you use your swim spa throughout the seasons, it’s a good idea to set up a quarterly deep cleaning schedule. The ideal instructions should be in the owner’s manual.

Yes, they provide full-service inspections, identifying and resolving any potential equipment problems.

The Bruce, WI homeowners’ guide to pool and spa services

From average costs to expert advice, get all the answers you need to get your job done.