Get matched with top grill repair technicians in Meadows Of Dan, VA

Yes, a drip edge is necessary on a metal roof, according to the International Residential Code (IRC). Drip edge flashing prevents water from dripping onto and behind your fascia board, which prevents the board from rotting and reduces the risk of water damage behind it. On gable ends, you can either install drip edge flashing or gable-end flashing to avoid the same issues.

A metal roof will last for an average of around 50 years—usually between 40 and 75 years—which is about double the lifespan of an asphalt roof—between 15 and 30 years or 25 years on average. Installing a metal roof is usually more expensive than an asphalt roof, with an average cost of $11,400 compared to the $9,200 for an asphalt roof. However, given that a metal roof costs about 20% more and lasts twice as long, it’s typically well worth the investment and should save you money in the long run.

When choosing a metal roof, consider not only the area of the roof but also the thickness of the panel, known as the gauge. Common roofing gauge sizes for metal roofs are 24-gauge and 26-gauge. The smaller the gauge size, the thicker the roof. Usually, a thicker gauge is ideal if your house is in an area that sees a lot of rain, snow, or hail, as it will be less likely to dent.

Yes, you can salvage grill grates with some surface rust. Simply apply a commercial rust remover or a homemade vinegar, baking soda, or lemon juice paste with a wire brush or steel wool. After removing the rust from the metal, you can then apply a thin layer of rust-preventing oil to keep the grates looking good as new for longer. However, grate replacement is often better when the rust is deep.