Top-rated concrete cutting pros.

Get matched with top concrete cutting pros in Cross Junction, VA

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete cutting project in Cross Junction, VA?

Select your specific project to find the pro for you.

Find Concrete cutting pros in Cross Junction

Waterproofing INC
4.6(
154
)
Concrete - Sawing or RemovalConcrete - Sawing or Removal- For BusinessConcrete Flatwork - Repair & Resurface

Serving Cross Junction, VA and surrounding areas

In business since 1982

Free estimates

Emergency services offered

"We have a finished basement and a crawl space in the storage area of our basement.  We have found after large rain storms recently water has been increasing in our crawl space. After one storm we found over 6 inches of water above the gravel in the crawl space and purchased a temporary pump to pump out the water, discarded the plastic vapor barrier with concern of mold growing on it and began to see seepage through the foundation wall to the basement. 
In order to find a solution we scheduled four appointments with Angie's list highly regarded basement waterproofing contractors.  We were surprised to find that each contractor provided different solutions ranging in cost from $13,814 to $1,950.  We were impressed with Mr. Norfolk's honesty and straight forward approach.  He noted that he could do some of the solutions provided by other contractors with piping systems to a sump pump but suggested to start with a more cost effective solution of just adding a sump pump to the crawl area and replacing the current basement sump pump that was 27 years old.  If additional solutions were needed in the future he could preform them but why spend the extra money at this time if not necessary. The work was performed on February 1st and took two workman 3.5 hours to complete.  The workman explained how the system worked and asked that we please follow up if we had any questions.  The only area I could see improvement was clean up as after they cleaned up I had to again sweep the work area and vacum the carpets covered by their drop cloths. There was also debris and concrete mix left on the driveway.
"
Recommended by97%of homeowners
Avatar for M.C. Fence and Deck
M.C. Fence and Deck
4.6(
442
)
Concrete Flatwork - Repair & Resurface

Serving Cross Junction, VA and surrounding areas

In business since 2005

Free estimates

Credit card accepted

"Vernon and the entire team at MC Fence did a remarkable job from beginning to end of our fence demo/install. I was amazed at how fast and efficient they worked and got everything done in 1 day! Vernon was also a dream salesman to work with as he was always there to answer any questions we had and is very prompt with his response time. I would absolutely recommend this company to family and friends!"
Privacy wood fence in northern VA
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+33

Recommended by94%of homeowners
Avatar for Metropolitan Chimney Masonry Services Inc
Metropolitan Chimney Masonry Services Inc
4.7(
200
)
Concrete Flatwork - Repair & Resurface

Serving Cross Junction, VA and surrounding areas

In business since 2001

Free estimates

Emergency services offered

"The company was responsive - gave me a same-week appointment.  Adolfo came to my house, assessed the work to be done, and quoted me a fair price.  He did the work right at that time.  The job was done well - it looks professional and neat.   He even colored the concrete so the patches would better match the existing concrete.  I am pleased with the work.
"
2014 Super Service Award Winner!
2014 Super Service Award Winner!
Recommended by92%of homeowners
Avatar for J & G Masonry & General Contractors - Glenn Taylor
J & G Masonry & General Contractors - Glenn Taylor
4.4(
28
)
Concrete Flatwork - Repair & Resurface

Serving Cross Junction, VA and surrounding areas

In business since 1967

Free estimates

Emergency services offered

"We met with Glenn and Josh a few times before beginning the project. They had a nice professional proposal and were always responsive on the phone. They preferred phone and mail over email but that was fine with me.   I priced out about 8 different masonry companies since the price for this foundation and slab was all over the map (range from 9k to 24k).  J&G was slightly higher than the lowest company but their customer service, reputation on Angieslist, and responsiveness made us select them.  We had a few weather delays.  Glenn was great at explaining what they were doing and when.  If I asked them to tidy up the site, they took care of it right away.
 
They laid the rebar for the footers and while we waited for inspection, the rain made a big mess of everything.  After waiting for the ground to dry out, they cleaned up the holes and removed all the soft mud.  The rebar was all put back into place and we were able to pour the concrete and have it set up.  We also had a piece of rebar attached to the footer rebar for a footer electrical ground.  Once our electrician comes out, the grounding wire can be tied in to the rebar. 
After that week, things moved a bit faster with building the block walls with anchor bolts, backfilling, adding a load of gravel for grading, and finally pouring the slab.  In their proposal, Glenn had written that they would do the 6" wire mesh in the slab but then proposed having the concrete supplier add fiber reinforcement to the concrete at the plant instead.  The inspector was okay with this change.  My understanding is that while the fiber reinforced concrete is slightly more expensive, it's less labor.
It's been about 3 weeks and we are very satisfied with the work J&G performed.  Other contractors have all said it looks like they did a great job."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+10

Recommended by100%of homeowners
Avatar for Ace Lawn & Landscaping
Ace Lawn & Landscaping
4.4(
60
)
Concrete - Sawing or RemovalConcrete - Sawing or Removal- For BusinessConcrete Flatwork - Repair & Resurface

Serving Cross Junction, VA and surrounding areas

In business since 2009

Free estimates

Emergency services offered

"They worked very hard to level and square the retaining walls and patios. We were very impressed by the lack of cutting corners. Our original patio and retaining walls were never properly installed and they appear to have corrected this problem. For years, we also had a drainage problem on the two sides of the house. They installed a French drain on one side and a basin drain on the other. Time will tell if this completely solves the problem, but the drains were working over the last two days of rain. We were so impressed by the quality of their work that we are having them come back to do a few more landscaping items.
"
Recommended by86%of homeowners
Avatar for PHX Electrical Contracting
PHX Electrical Contracting
4.8(
64
)
Concrete Flatwork - Repair & Resurface

Serving Cross Junction, VA and surrounding areas

In business since 1989

Free estimates

Emergency services offered

As the owner of PHX Contracting I would like to offer you a 100% satisfaction promise, If for any reason you are not completely satisfied please call me directly and I will resolve any issues \nGreg Schick / President \n\nPHX Electric is a full-service plumbing and electrical contractor and service company based in Northern Virginia serving customers throughout Virginia, Maryland and DC. From installations and repairs to preventative maintenance, our company welcomes jobs of all sizes and we have extensive experience working with countless residential and commercial customers. Whether you need a new ceiling fan or a back-up generator, you can depend on our expert electricians to take care of everything for you for an affordable price.

Home Adviser Pro
Angie's List
Gen. Wiring
Generac Dealer
Gen. Install

+10

Recommended by93%of homeowners
...
Showing 1-10 of 65
Concrete Cutting questions, answered by experts

Sawing your hot tub into more manageable chunks so it can be lifted easily into a truck takes several hours. Generally, 2.5 hours for smaller hot tubs and around 4 hours for larger ones with the help of one to two people. If money isn't a concern and you want to skip the physical labor, you can hire a pro to get the job done.

Since water heaters are primarily made of metal, they’re commonly accepted by scrap yards and collectors. Don’t expect to fetch a high price, though—water heaters are mostly steel and aluminum, which aren’t high-value metals. Some components are made of more valuable metals, like brass and copper, but they’re a small portion of the heater and won’t affect the price much.

The average cost for a welding project is about $300, with typical costs ranging from $125 to $490. However, prices can be as low as $125 for very small jobs or exceed $1,200 for large or complex projects. Welders typically charge an hourly rate between $65 and $150, depending on their experience, and many charge a minimum fee to cover overhead and travel expenses. The total cost is influenced by several factors, including labor, the cost of materials like metal rods and shielding gas, the type of metal being welded, the project's size and complexity, and your geographic location. For a precise quote, it's best to ask a local welder for an estimate based on your specific project.

Yes, but you’ll need reliable steel-cutting tools and safety gear to get started. Shipping containers are typically around ¾ inch thick, so it’s entirely possible to cut through them, but experience and the right equipment are very important. When possible, try to get a container as close to the size you want it as possible.

Yes, you can cut up a box spring., but you’ll need to do so in layers. You can clear the fabric and fluff away to reveal the springs before removing them as well.

The Cross Junction, VA homeowners’ guide to concrete cutting services

From average costs to expert advice, get all the answers you need to get your job done.