Top-rated electricians.

Get matched with top electricians in Thatcher, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Thatcher, UT?

Select your specific project to find the pro for you.

Find Electricians in Thatcher

Avatar for Neli Virtual Appliance Repair
Neli Virtual Appliance Repair
4.2(
654
)

Serving Thatcher, UT and surrounding areas

Approved

In business since 2016

Free estimates

Warranties offered

"The problem turned out to be a burned out small electric door switch. I believe the price was way too expensive for the service performed and the price of the door switch. What more can I say? It got done."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Response time1 day
Recommended by88%of homeowners
...
Showing 1-10 of 70
Electrical questions, answered by experts

The size of the microwave you choose may change this answer, but for standard over-the-range microwaves, 120 volts and a three-prong grounded outlet is needed for your device.

Yes, in a new home, ground wires are mandatory. Some older homes may not be grounded, but if you decide to renovate, you will need to have your electricity grounded at that time. Remember, grounding helps keep everyone in your home safe from sudden electrical surges. It’s best to hire an electrician to inspect and work with your home’s wiring.

The number of outdoor outlets that can be on one circuit depends on the circuit's capacity and the electrical load of each outlet. Outdoor outlets should ideally be on a dedicated circuit that is not shared with other outlets, and each outlet should be rated for at least 15 amps. A circuit rated for at least 20 amps is recommended. It’s important to use GFCI protection for all outdoor outlets to prevent electrical shocks. Overall, it's crucial to avoid overloading the circuit and take necessary safety precautions.

The most common reason a GFCI outlet would trip even when nothing is plugged in is if there’s a problem at the circuit breaker end. This could be an overloaded circuit, with too many appliances plugged into it, or another type of fault. If a GFCI outlet keeps tripping, it can also be because it is faulty and needs replacing.

If there isn’t a C-wire on your thermostat, you can repurpose the G-wire. The G-wire controls the fan independently of the other controls on your thermostat, so the fan-only function won’t work if you decide to go this route.

The Thatcher, UT homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.