Get matched with top fencing pros in Stinnett, TX

Silt fences are very effective when installed correctly and used in proper locations. However, there are places where they don’t work as well. This includes property with a concentrated water flow, where runoff could pool or cause a flooding hazard. You’ll also want to use caution when installing in areas susceptible to landslides. Your contractor will follow state guidelines and know when an alternate solution is more effective.

You can DIY a stockade fence installation, but prepare to put in some good sweat equity. For the best results, carefully plan the exact location of your fence before you break ground. In particular, carefully map out your post locations before setting them in concrete. Be sure to call your local utility company before digging to avoid damaging underground wiring and causing severe injury.

On the other hand, installing stockade fencing on your own might sound too overwhelming. It’s certainly time-consuming and labor-intensive. Besides the hard work, you must install it properly to avoid gaps. Unless you’re confident you can get the job done right, hiring a privacy fence installer near you is the way to go.

While most homeowners aren't required to tell their neighbors that they’re putting up a fence, it's certainly a good idea to do so. Not only is it considerate to give neighbors a heads up about construction noise, but building a fence may limit your neighbors' access to their own backyards while building is taking place. 

Ideally, when you replace a fence post, you should also replace the concrete footing. The concrete bonds to your new post, creating a secure base. If you install a new post into old concrete, it won’t be as sturdy.

That said, it is possible. Sometimes the post will lift right out of the concrete. If not, you can use a high-lift car jack to try and lift the pole out of the footing. Put the new post into the same hole and backfill it with fast-setting concrete. Keep in mind, this won’t work well for metal posts.