Top-rated excavation pros.

Get matched with top excavation pros in Robstown, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your excavation project in Robstown, TX?

Select your specific project to find the pro for you.

Find Excavation pros in Robstown

Avatar for J&S Geyer, LLC
J&S Geyer, LLC
4.4(
8
)
Building Site - Preparation and Clearing - For Business

Serving Robstown, TX and surrounding areas

Approved

In business since 1990

Free estimates

Emergency services offered

"The guys were on time and did an amazing job clearing land and disposing of debris on my property. I added a couple of little things that I needed done. The price was very fair and they were quick to get it done. I there was no riding the clock to run my bill up. I definitely would not use any one else."
Response time2 days
Response rate95%
16 neighbors recently requested a quote
...
Showing 1-10 of 81
Excavating questions, answered by experts

Excavation is priced in cubic yards, so you’ll need to find the volume of the area in order to calculate costs. Multiply the length, width, and proposed depth of your excavation site, then convert it into yards to get the volume. Multiply this figure by the price per cubic yard.

Most homeowners can measure by hand to get a rough estimate, even if it’s tedious. You may want to pull out a tape measure or use a string to help mark the area.

A trench that is less than 5 feet deep often doesn't require a protective system. Most residential trenches will not go this deep (the typical residential drainage trench is just 18 inches deep). In the event that an excavator needs to dig more than 5 feet beneath the surface, a protective system is required unless the excavation is in entirely stable rock.

It takes one hour to dig a 10-foot trench by hand. Use a trenching shovel with a sharp tip and a long head. Plan for more time if your soil is heavy or rocky. Consider renting a trencher if you’re digging a long or deep trench or if you have challenging soil or terrain. 

The rules and regulations regarding groundwater use vary between states. To find out if you can dig a well on your property, you’ll have to consult these regulations, address any compliance requirements, and get the appropriate permits. It’s also important to check that your intended location has the right geology and water table to support a well.

You should dig 3 to 6 inches deep for plastic edging. Dig as wide as you need to fit your plastic edging into it—2 inches is usually sufficient.

The Robstown, TX homeowners’ guide to excavation services

From average costs to expert advice, get all the answers you need to get your job done.