Get matched with top boiler installation pros in Keller, TX

Scale from hard water is hard to diagnose until it starts causing problems. If your area has particularly hard water, that’s most likely what your boiler is using. If scale build-up becomes a problem, it starts to cause decreased flow and heating, and eventually, valve failures as valves become blocked. Let boiler professionals know if you’re worried about scale and they can offer advice or implement a solution.

Yes, most municipalities require a permit for propane boiler installation to ensure safety and code compliance. Permit fees vary by location and are often included in your installer’s quote, as they’ll handle the permitting process. Ensure that you always check local regulations before starting your project to avoid fines or delays.

Hydronic and standard electric baseboard heaters differ in how they operate, their cost, and their performance. Standard convection heaters use electric coils to heat the air directly, while hydronic heaters warm a contained liquid like water or oil, which then radiates heat into the room.

In terms of cost and efficiency, hydronic heaters usually have a higher upfront price but are more energy-efficient and cheaper to run over time. This is because the heated liquid retains warmth, allowing the heater to continue providing heat for a while after the thermostat turns it off. In contrast, electric heaters provide heat more quickly but are less efficient.

Ultimately, the better choice depends on your priorities. If you need a room to heat up fast and have a lower initial budget, an electric heater might be suitable. If long-term energy savings are more important and you don't mind a slower heat-up time, a hydronic heater is likely the better option.

An expansion tank must always be installed on the supply side, which is the side where the boiler sends water out to heat the systems. That placement allows the water to push against the air and condense properly as it is heated, then circulated through the system. Professional installers can recommend the best place on the supply side for an expansion tank.