Top-rated septic tank pros.

Best septic tank pros near Edcouch, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your septic tank service project in Edcouch, TX?

Select your specific project to find the pro for you.

Top-Rated Septic tank pros in Edcouch - Updated Nov 2026

LJH Septic Tank Service
New to Angi
Septic System - Install or ReplaceSeptic System - Repair

Serving Edcouch, TX and surrounding areas

In business since 1986

We at LJH Septic Tank Service work hard for our customers , that are looking for quick professional , honest ,response to their septic problems. Thirty years in the construction industry and twenty years in hte septic tank business gives our customers the expertise we need to take care of their problems.We visit customers all over the Rio Grande Valley ,give them free estimates and advice .

Avatar for OTM PLUMBING
OTM PLUMBING
5.0(
1
)
Septic System - Install or ReplaceSeptic System - Install or Replace - For BusinessSeptic System - Repair+3 more

Serving Edcouch, TX and surrounding areas

In business since 2016

Free estimates

Emergency services offered

We specialize in both residential and commercial work.\n-Cutting, welding and assembling pipes, tubes, fittings, and fixtures.\n- We do Underground work\n-Install fittings and valves\n and much much more.\n\nWe value your time so everything will be done according to your timeframe. \n\n\n

Recommended by100%of homeowners
Septic Tanks FAQs, answered by experts

A septic tank with a 1,500-gallon capacity is good for larger homes with up to 6 or 7 bedrooms. The average home can go with a smaller tank, about 1,000 gallons, which supports a home size of up to 2,500 square feet, or a home with about three bedrooms.

For the most part, choosing between 30/50 psi and 40/60 psi is based on your water-pressure preference. However, it can also depend a little bit on your house—if you have older plumbing, a lower water pressure can be easier on the pipes (and a bit more gentle on your well pump). 

The lower 30/50 pressure is usually enough for a single-story home, but you may want 40/60 if you have multiple stories, as the extra pressure helps water flow smoothly up to the second floor.

Consider site conditions, soil type, required capacity, and system designs compatible with environmental protection regulations.

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

French drains, sump pumps, and exterior waterproofing systems are common options. Choose one that best suits your property’s needs.

The Edcouch, TX homeowners’ guide to septic tank services

From average costs to expert advice, get all the answers you need to get your job done.