Get matched with top countertop and backsplash pros in Barrett, TX

Yes, you can install a new layer of laminate over an existing laminate countertop, which can save you time and money while updating its appearance. The process is similar to installing laminate directly onto particle board. First, clean the existing countertop thoroughly. Next, fill and sand any cracks or damaged areas. Then, you'll need to sand or scratch up the entire surface to help the contact cement or glue adhere properly. After applying the adhesive, you can install the new laminate layer on top. If you're looking for other ways to improve your existing laminate countertops, you could also consider painting them or applying an epoxy finish.

You attach solid surface counters with construction adhesive. Once your slab is ready, you fit it to the wall, apply the adhesive, and secure it in place with clamps until the glue dries. This usually takes several days. 

Afterward, you install the backsplash, faucets, and more. At this point, you can caulk the counter, allow it to dry for 24 hours, and then you're done with the installation.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

Most recycled glass countertops are nonporous, so they don’t require sealant. There is, however, one major exception. If your recycled glass countertop contains a cement binder, it’ll require an additional layer of protection. Seal these countertops once or twice a year. Use a concrete sealant and finish it with a food-safe wax for a gorgeous and shiny finish. Otherwise, just clean the countertop regularly and always use a cutting board.