Get matched with top concrete resurfacing pros in Veblen, SD

While you don’t technically need to grind concrete before resurfacing, it is very helpful. Grinding creates a rough, porous surface on the concrete, which gives the resurfacing material something to latch onto. Grinding your concrete before resurfacing can ensure that your resurfacing material lasts longer, reducing additional concrete resurfacing costs down the line.

Properly prepared and applied concrete resurfacing can last from 10 to 15 years. The longevity of resurfaced concrete depends on proper preparation as well as the fundamental condition of the original concrete. Depending on the application used to resurface the concrete, reapplying a protective sealer every two to three years can extend the life of the new concrete surface.

Resurfacing a concrete slab can be worth it if the concrete is in decent condition and has minor cracks, chips, or discoloration. If the concrete is cracked, peeling, sunken, or broken up, then replacing your concrete is probably more cost-effective in the long run and will give you a better outcome. Resurfaced concrete is only as good as the concrete underneath the new overlay material. If the concrete is peeling or cracked, the peeling and cracks are likely to show through the new surface.

Concrete blemishes such as chipped steps or small cracks are fixable with patching. For bigger jobs, including driveway repair and cracks wider than a 1/4 of an inch, patches will only serve as a temporary fix. Resurfacing is ideal when the surface is showing more widespread wear—like if it’s pitted, rough, or has lots of cracks. Resurfacing gives your concrete a fresh, like-new appearance without needing a full replacement.

When the concrete is severely cracked, sinking, or otherwise structurally unsound, replacing it might be your best option. Replacement ensures the safety and longevity of the surface in this case.