Top-rated above ground pool installation pros.

Best above ground pool installation pros near Selby, SD

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Selby, SD?

Select your specific project to find the pro for you.

Top-Rated Above ground pool installation pros in Selby - Updated Nov 2026

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Above Ground Swimming Pool or Accessories - Repair or Service

Serving Selby, SD and surrounding areas

In business since 1971

Credit card accepted

"AHS is ok. They cover repairs of most everything under the roof of your house. The companies that contract with them are not always the best. You call AHS with the issue, they send a fax to the repair company and give you the contact info. If they don't contact you within 24 hours, you call them. Sometimes they answer, sometimes they don't. When they arrive (usually three days or so later), they service the item. if it has issues within the 90 days, you call AHS again, they are sent out with no charge. If the serviceman decides the unit is unrepairable, AHS will allow you to choose a replacement from their listing (usually not as good as what you have) they will install and remove your old item, or give you wholesale amount to buy and install your own. Prices vary on what you want covered and what you want the copay to be, plus where you live. For me it is 49.99 per month with a 75.00 time of service order. You can have more than one item serviced at the same time under the same fee. If you have a SEAR product the repair guys are great. Not that wild about the other ones they send out. But it is a big savings compared to calling someone on your own. The cost of service is only the 75.00 copay."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Request Quote
Install Above Ground Pools FAQs, answered by experts

Yes, a pool with a heater will lose more water. The heater warms the water, which increases the rate of evaporation. To minimize water loss from evaporation, you can install a pool cover and keep the pool covered when it is not in use.

Don’t worry if your pool is still cloudy right after shocking it. Some shocking products will leave your pool cloudy for a day or so after using them. However, if your pool is still cloudy several days after shocking it, it could be due to poor filtration, low chlorine, or one of the other problems outlined above. If you’ve tried our fixes but still can’t clear the cloudiness, call a pool repair professional.

While you can install an above ground pool on most level surfaces, you’ll need sand to protect your liner from tearing. For example, rocks, plants, and twigs can take a toll on your liner. Adding sand will help level the pool even more. For additional support, you can also use angled foam or a foam pool cove.

The steps to fill a swimming pool will depend on your local building codes. However, it starts with draining the pool of all water using a submersible pump. Then your pro will lift the pool shell from the ground or break it into pieces for individual removal. The next step is filling the cavity with dirt and gravel and topping it with topsoil. Once a structural engineer deems the site safe, landscaping can start.

If you put too much baking soda in your pool, your alkalinity will rise. That means you’ll need to take steps to lower your alkalinity. You can either add more water (which will require more chemicals because they’ll be diluted), wait for the alkalinity to lower naturally, or use a chemical like muriatic acid to lower it. 

The Selby, SD homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles