Top-rated plaster repair specialists.

Get matched with top plaster repair specialists in Platte, SD

Enter your zip and get matched with up to 5 pros

Need a pro for your plaster repair project in Platte, SD?

Select your specific project to find the pro for you.

Find Plaster repair specialists in Platte

Plaster Repair questions, answered by experts

You will be placing holes in the wall to hang the mounting bracket. If you’re mounting a large TV, the bolts in use could make significant holes around half an inch in diameter. Other than a few holes, though, the process of mounting the TV should not cause significant damage to the wall, unless you make an error and miss the wall stud, tearing out drywall. Should you decide to remove the mount later, the DIY drywall repair cost for a small hole usually is $10 to $30. It’s a repair you can do in a few minutes.

Costs range from $200 to $800, depending on the area size and damage severity.

You can put certain types of plaster over other types, but doing so isn't always the best idea. For example, putting a coat of gypsum over lime plaster is possible, but doing so will limit the lime plaster's breathability and potentially affect its performance.

Since cement plaster tends to leave a textured surface, no matter how much you smooth it, some people prefer to use gypsum plaster as a topcoat over cement plaster, creating a smoother surface.

Yes, you can speed up the time it takes for plaster to dry, but it's important to do so carefully to avoid issues like cracking or crumbling. Proper ventilation is key; open a window or use a fan to circulate air in the room. Heat can also accelerate drying, but be cautious, as too much heat can cause the plaster to dry too quickly and crack. Check the plaster's packaging for the recommended drying temperature and set the room's thermostat accordingly. While managing humidity is important, avoid using a dehumidifier, which can remove moisture too aggressively and result in crumbly plaster.

Yes, you can apply new plaster over an existing plaster surface, such as a wall or ceiling, provided the old plaster is in good condition. Before you begin, check the stability of the existing plaster. The surface must be clean, free of loose material, and have no peeling paint. It is also recommended to roughen the surface slightly to promote adhesion. For older plaster, applying a base coat like a PVA emulsion or a specific bonding agent or primer is crucial. This step makes the existing plaster less porous and ensures the new and old layers adhere properly for a smooth, long-lasting finish.

The Platte, SD homeowners’ guide to plaster repairs

From average costs to expert advice, get all the answers you need to get your job done.

See all articles