Top-rated stucco pros.

Get matched with top stucco pros in Marty, SD

Enter your zip and get matched with up to 5 pros

Need a pro for your stucco service project in Marty, SD?

Select your specific project to find the pro for you.

Find Stucco pros in Marty

Stucco questions, answered by experts

Stucco is very challenging to DIY, so it’s always best to leave the work to professional stucco contractors. The same recommendation applies to painting a stucco house, which should be left in the reliable hands of a professional exterior painter. Inexperienced DIYers can make several critical mistakes during stucco application, such as:

  • Failing to apply sufficiently thick layers for longevity and water resistance

  • Uneven application

  • Uneven texture across the exterior

  • Mixing the stucco improperly, leaving a weak structure

  • Failing to texture properly in between coats, leading to cracking and chipping

When cleaning stucco siding, it is recommended to use a pressure washer with a psi (pounds per square inch) between 1,500 and 2,000. This range provides sufficient power to remove dirt and grime without causing damage to the stucco surface. It's important to avoid using excessive psi as it can chip or crack the stucco. 

Using a wider spray nozzle and keeping a safe distance of about seven to 10 feet from the siding helps ensure a gentle and effective cleaning process. Always follow the manufacturer's guidelines and adjust the psi accordingly based on the condition of your stucco and the specific requirements of your pressure washer.

Depending on the amount of damage, a stucco repair professional can repair your stucco siding in four to 12 hours. If you only have a few small cracks, that repair could take as little as one to two hours to repair. In contrast, if you have an extensive fix, like foundation or chimney repair, you can expect the process to take a bit longer. Always discuss your project expectations with your stucco repair expert.

A standard drill will work just fine if you’re drilling small holes, and only a few of them. But anything with a diameter larger than 3/8 inch is best done with a hammer drill, since it is stronger, faster, and also makes your drill bits last longer. While you don’t absolutely need a hammer drill for stucco, it is a worthy investment if you think you might drill more holes down the road.

Yes, most services include matching the replacement pieces to the existing flooring. Confirm with your contractor.

The Marty, SD homeowners’ guide to stucco services

From average costs to expert advice, get all the answers you need to get your job done.