Best water heater pros near Avon, SD

Unless you have previous plumbing experience or extensive experience with water heaters, you should avoid replacing your electric water heater yourself. This process involves disconnecting wiring and parts from the old water heater and reinstalling them onto the new one, among other difficult tasks. This job is best left to the pros to make sure that everything is connected correctly to avoid serious leaks or malfunctions.

A water heater is one of the heaviest hitters in your home, and it needs as much power as possible to help it run efficiently and effectively.

Your water heater should be on its own dedicated circuit breaker, with no other power sources running to it. This is required to meet the National Electric Code–and to ensure it runs as efficiently as possible.

Most standard residential water heaters, which are typically around 40 gallons and use 240 volts and between 3,500 and 5,500 watts, require a 30-amp, two-pole circuit breaker. For smaller, point-of-use water heaters using 120 volts and between 1,500 and 3,000 watts, a 30-amp breaker is also often adequate. However, some models may have different needs; units that use more watts than average may require a 40-amp breaker, while smaller units might only need a 20-amp breaker. Newer, tankless, or more energy-efficient models can also require a higher amperage. Having the correct breaker size is crucial for safe and efficient operation, so it's best to consult a licensed electrician to determine the specific needs of your water heater.

If your water heater is about to celebrate the big 2-0, you may want to consider sending it off to greener pastures. While the water heater may seem to be working well, any conventional, tanked water heater over 10 years of age is at risk of failure. If your water heater is 20 years or older, your best move is to replace your aging heater before it completely breaks down.