Top-rated contractors.

Get matched with top contractors in Bishopville, SC

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Bishopville, SC?

Select your specific project to find the pro for you.

Find Contractors in Bishopville

John Marshall Sturgess Builder
4.4(
5
)
Major Home Repairs (General Contractor)

Serving Bishopville, SC and surrounding areas

Approved

In business since 2010

Free estimates

Emergency services offered

"This was my first experience hiring a contractor and Mr. Sturgess's was great to work with. He was able to meet with me outside of my work hours to go over my plans. His crew was on time, friendly, and answered any questions I had. Mr. Sturgess rates were very reasonable, and he and his team are very honest and easy to work. Since they have finished converting my carport to the screened sun room, I asked if they could go ahead and finish some other projects for me. I can't wait until all of my projects are done."
Response time4 days
Response rate100%
7 neighbors recently requested a quote
Avatar for Luke's Painting Company
Luke's Painting Company
4.4(
40
)
Major Home Repairs (General Contractor)

Serving Bishopville, SC and surrounding areas

In business since 2017

Free estimates

Credit card accepted

"Luke was a gift! He responded quickly to my call and was able to start painting two days later. He was professional, knowledgeable, on time and always cognizant of the fact that I was working from home while he was painting. He meticulously painted my entire house and it looks amazing. I highly recommend Luke, you will not be disappointed."
After.. what an amazing difference!
After picture of the beautiful entryway
after picture of the fence
after.. beautiful color!
Exterior Painting in Sellers, SC

+76

Recommended by93%of homeowners
Showing 1-10 of 41
Unfinished Carpentry questions, answered by experts

There are approximately 5.33 board feet in a 2x4. You can use the board foot calculator in this article to easily find the answer. A 2x4 is 2 inches of thickness by 4 inches of width, so you need to find the length, with 8 feet being the most common. You’d use the calculator here to multiply 2 times 4 times 8, and then divide by 12, arriving at a total of 5.33 board feet. 

Costs depend on furniture type, size, complexity, and whether additional modifications are needed.

Bump-out additions can add some space to a closet without requiring any significant structural work. This entails pushing back the existing rear or side of the closet, simply moving the wall into either an adjacent room or unused space. For ground-floor closets, this could even be extended to the exterior of the home, but that has its own complications. Bump-outs are a good discussion to have with your contractor if you’re just looking to increase the space a little—not renovate the entire closet space.

While framing a basement is not as difficult as finishing a basement, it's something you should typically leave to the pros. That’s because if something is installed correctly, it will affect your entire basement. However, you can take care of some of the smaller tasks, like filling holes or putting up some insulation.

Yes, you will need a jack for a rim joist replacement. To prevent sagging and facilitate the removal of load-bearing wood, you’ll need to relieve the pressure from this joint before beginning work. 

Due to hydraulics and other specialized equipment, a sill plate and rim joist replacement are not typically a DIY project. Hiring a professional structural engineer and experienced contractors is the best approach to replacing rotted sill plates and rim joists.

The Bishopville, SC homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.