Get matched with top electricians in Bishopville, SC

Yes, electricians must be licensed, certified, and in most cases, insured. Licensing requirements vary by state and local municipality, but most U.S. municipalities require electricians to hold an electrical contractor’s license. It's always a good practice to confirm requirements with your local municipality. Even if licensing is not required in your area, hiring a licensed and experienced electrician often leads to a better end result.

A license is a legal requirement to operate a business and is necessary for pulling project permits. Certifications, on the other hand, are typically voluntary and demonstrate a certain level of expertise. In some cases, a certified electrician may send an apprentice or journeyman to perform the work, but they must operate under a primary electrician who holds the proper license.

Before hiring, you should verify the electrician's license, insurance coverage, and any third-party certifications. You can use Angi’s contractor licensing search to confirm a pro's license status. Additionally, businesses with the “Angi Approved” badge on our platform meet strict criteria, including having the required state and local licenses, passing a background check, and maintaining a high average rating.

Most 200-amp panels have 40 to 42 slots, which can accommodate 40-42 single-pole breakers or 20 double-pole breakers. Some panels can accept even more circuits through the use of tandem breakers. The exact number of breakers allowed is determined by the panel manufacturer's rating, which you can find on the panel itself. It is important to avoid using all breakers at the same time; as a general rule, you should not use more than 160 amps of power at once to prevent overloading your 200-amp system. For specific guidance, it's best to check your panel's rating or consult with a qualified electrician.

While circuit breakers are designed to be reset after tripping, there isn't a strict countdown to when they will fail. The primary danger lies in a breaker tripping multiple times in a short period without allowing the components to cool down. Theoretically, a standard breaker might handle around 50 trips caused by simple overloading. However, this number can be much lower in practice. For instance, a high-current fault could damage a breaker to the point that it needs replacement after only two resets. Repeatedly resetting a breaker that trips frequently exacerbates the underlying problem by causing the electrical components, wires, and the breaker itself to overheat. This can lead to permanent damage, cause the breaker to trip unnecessarily in the future, and increase the risk of an electrical fire. If a breaker trips every few minutes, you should leave it in the 'off' position and call a qualified electrician for an inspection.

No. Do not use a 14-gauge wire on a 20-amp outlet. A certified licensed electrician would know that the National Electrical Code (as per Section 240.4(D) subsection 3) requires 14-gauge wires to be used with a maximum amplitude of 15. Therefore, you should only use 12-gauge wires on 20-amp outlets.