Top-rated septic tank pros.

Get matched with top septic tank pros in Tyrone, OK

Enter your zip and get matched with up to 5 pros

Need a pro for your septic tank service project in Tyrone, OK?

Select your specific project to find the pro for you.

Find Septic tank pros in Tyrone

Avatar for Roger Allen Restorations & Homes
Roger Allen Restorations & Homes
4.3(
19
)
Septic System - Install or ReplaceSeptic System - Install or Replace - For BusinessSeptic System - Repair+3 more

Serving Tyrone, OK and surrounding areas

In business since 1947

Free estimates

"I recently purchased a Fannie Mae foreclosure, a house with nice potential but quite a mess to get started with.  I contacted a couple of names from Angie's List and Roger Allen was so professional from the get go (good guy too), I went with him pretty quickly.  He was able to get an estimate together and to my lender soon after I had asked.  I'm not an expert on pricing but his numbers were consistent with the other I had received and ended up being accurate by the time everything was done.  On small jobs that is easy, on the mess that was my house, quite a challenge.  We had problems all around from an iffy septic system, siding peeling away, no hot water heaters, ancient electrical boxes, decor from a generation long past, leaks in the shower/master bath, carpeting that had seen much better days, etc.  He was able to take care of everything inside of my budget without any glaring omissions.  Even when my wife picked out expensive paints, he was able to take care of the overage.  Roger and his people have been great, I'll be using him for any future fix-it jobs in the future for sure."
A small portion of a custom kitchen
Another kitchen with glass and enviroglass countertop
A million dollar foyer...
Installed Travertien after reinstalling a new concrete shower pan
The final finish

+2

Recommended by72%of homeowners
Septic Tanks questions, answered by experts

The best times of year to empty or pump a septic tank are spring and fall. Many professionals recommend spring because the ground has thawed, making the tank easier to access and the waste less likely to be frozen. Pumping before summer also helps avoid conflicts with vacations or outdoor gatherings. Fall is another great option, as contractors may be less busy, and servicing the tank can reduce the risk of overflow from winter and spring precipitation. While summer is also a suitable time, winter is generally not recommended due to frozen ground.

Perc rates vary dramatically, and a good perc rate could be anything from 5 minutes per inch of drainage to 60 minutes per inch. The lower the number, the faster your system will drain and the more effective it will be. A 60-minute-per-inch drain rate is the highest number considered to be good, or even allowable, draining.

It only takes a few days for a septic tank to fill with water after a pro has pumped it. This is completely normal, and the water is a vital part of your septic system’s wastewater treatment process. The water that fills your tank days after pumping is not the same as the tank being filled with waste. You shouldn’t have to pump your septic system more than once every three to five years unless you have a tank that’s too small for your home’s water output or there’s a problem with your leach field. 

The efficacy of a drain field depends on a wide variety of factors, though a well-maintained one can last as long as 40 or 50 years. Of the different types of septic tanks on the market, concrete and plastic tanks tend to last the longest—upwards of 40 years if they’re pumped regularly—while steel tanks have a tendency to rust over time and may need to be replaced after 15 or 20 years.

The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.

For example:

  • If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.

  • If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.

Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.

The Tyrone, OK homeowners’ guide to septic tank services

From average costs to expert advice, get all the answers you need to get your job done.