Top-rated drywall pros.

Best drywall pros near Locust Grove, OK

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall service project in Locust Grove, OK?

Select your specific project to find the pro for you.

Top-Rated Drywall pros in Locust Grove - Updated Nov 2026

Avatar for H.E.R.C Painting and Coating
H.E.R.C Painting and Coating
5.0(
5
)
Drywall - Repair

Serving Locust Grove, OK and surrounding areas

Approved

In business since 2025

Free estimates

Credit card accepted

"HERC was absolutely top knotch. Everything was exceptional. Surfaces were properly prepped and primed and then painted with two coats to ensure superior results. The contractor maintained excellent communication, asking for homeowner's input whenever there was a question on how to proceed. The job was for an entire house consisting of 4 bedrooms, 2 bathrooms, a kitchen, a living room, a family room, and a stairwell. Doors, baseboards, ceilings, walls, and trim were all painted to perfection. I'd hire HERC again in a heartbeat!"
1 neighbors recently requested a quote
BBC Construction - Home Facebook
4.8(
4
)
Drywall - InstallDrywall - Repair

Serving Locust Grove, OK and surrounding areas

In business since 1995

Free estimates

BBC Construction is committed to excellence every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests and make their concerns the basis of our business.

Response time3 days
Recommended by100%of homeowners
Avatar for NDN Veteran Repairs
NDN Veteran Repairs
4.3(
40
)
Drywall - InstallDrywall - RepairDrywall - Repair - For Business

Serving Locust Grove, OK and surrounding areas

In business since 2021

Free estimates

Small jobs welcome

"They did a good job and were very nice. They secured all the project materials and delivered them. Worked on installation for garage door, winterized front door, made metal hand rails for storage building."
Response time2 days
Response rate97%
Recommended by78%of homeowners
...
Showing 1-10 of 105
Drywall FAQs, answered by experts

If you plan on heating your garage, you must install a vapor barrier when drywalling the garage. A vapor barrier protects your garage from frost and mold that can occur through condensation. If your garage is unheated, you don't need to install a vapor barrier. The only exception is if you regularly crank the heat in your car before getting in it. In this case, you may still want to install a vapor barrier, as your car can heat your garage.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

You can usually tell if you have plaster or drywall by touch (plaster is harder, colder, and smoother than drywall) or by tapping on it (drywall sounds hollow, plaster does not). If you still cannot tell, peek under an outlet cover and check the cut edges. The rough edges show the composition of the wall. You will see either drywall (two paper sheets sandwiching gypsum material) or only plaster material (no paper sheets).

You should not leave drywall outside, especially overnight or in a wet, humid climate. Exposure to rain and humidity can damage the drywall, weakening its structural integrity and making it susceptible to mold growth. If you must leave drywall outside during a project, be sure to cover it with a tarp or keep it inside a storage shed to protect it. Even drywall intended for exterior projects requires a protective moisture barrier. For best results, store any extra drywall in a dry area away from the elements.

The easiest way to remove texture from walls is the soak-and-scrape method. You’ll need to spray a section of the wall with water and let the water soak in and soften the texture. Then, you need to scrape the texture off using a drywall taping knife. This method works best with unpainted walls since paint prevents water from saturating the textured joint compound.

The Locust Grove, OK homeowners’ guide to drywall services

From average costs to expert advice, get all the answers you need to get your job done.