Top-rated fireplace pros.

Best fireplace pros near Garber, OK

Enter your zip and get matched with up to 5 pros

Need a pro for your fireplace service project in Garber, OK?

Select your specific project to find the pro for you.

Top-Rated Fireplace pros in Garber - Updated Nov 2026

Soot Busters Chimney Services
4.9(
100
)
Brick or Stone Fireplace (Gas) - InstallBrick or Stone Fireplace (Gas) - RepairBrick or Stone Fireplace (Non-Gas) - Install+12 more

Serving Garber, OK and surrounding areas

In business since 2012

"He inspected everything and left me a list of recommendations to be performed on the top of the chimney that included sealing it and installing a cap.  Chimney was in good shape.  He cleaned out the fireplace and tested lighting the logs.  Very professional and knowledgeable.  Will use again and will recommend to neighbors.
"
Recommended by98%of homeowners
Avatar for Frontpoint
Frontpoint
4.7(
8,819
)
Clean and Inspect a gas fireplaceClean and Inspect a wood burning stove or pellet stoveClean and Inspect a wood fireplace chimney

Serving Garber, OK and surrounding areas

In business since 2007

Free estimates

Emergency services offered

"It's a pretty decent system, I think. They send you the pieces and you install them yourself, which is pretty easy. The only real problem I have is that one sensor is too far away from the panel...or there's some interference, and they haven't been able to fix that. It's an interior door, so it's not the end of the world, just a little annoying. Their customer service is pretty good though. Nice, smart customer service people on the other end, very polite and helpful."
Recommended by93%of homeowners
Showing 1-10 of 21
Fireplaces FAQs, answered by experts

No, a chimney crown is not the same as a chimney cap. A chimney crown is a flat cement area on top of a masonry chimney. It starts where the masonry part of the chimney ends at the very top and domes upward toward the flue opening. A chimney cap sits on top of the crown over the flue. It is usually made of metal and allows smoke to escape without letting in rainwater.

You can, but you shouldn’t. While you can still start a fire in your fireplace, the smoke and other fumes won’t have a proper way to escape if the flue is cracked. By continuing to operate your fireplace, wood stove, or furnace, you are putting your home at risk of absorbing toxic byproducts of the fire source.

Yes, you can put a freestanding one in a corner if you’re tight on space. Because pellet stoves don’t get as hot as other types of wood stoves, there only needs to be 3 inches of clearance from the wall on each side. Placing it in a corner should not impact the ventilation—you’ll still need to follow safety precautions by not installing too close to a window. Typically, it’s 4 feet from a window or 18 inches if the stove uses an external air source for combustion. Always check the owner’s manual for specific instructions.

There are fire codes for a fireplace mantel made of wood or other combustible material. The mantel must be mounted at least six inches away from the fireplace opening on all sides with a non-combustible material—like stone or brick—installed between the mantel and fireplace. Building codes and regulations will vary based on your location, so before beginning the project, research the requirements in your area.

Costs range from $3,500 to $15,000, depending on material, labor, and design complexity.

The Garber, OK homeowners’ guide to fireplace services

From average costs to expert advice, get all the answers you need to get your job done.