Top-rated masons.

Get matched with top masons in Garber, OK

Enter your zip and get matched with up to 5 pros

Need a pro for your masonry work project in Garber, OK?

Select your specific project to find the pro for you.

Find Masons in Garber

Avatar for Groundworks
Groundworks
4.8(
49
)

Serving Garber, OK and surrounding areas

Approved (Corporate)

Super Service Award Winner

In business since 2000

Free estimates

Warranties offered

"everyone that I dealt with at Groundworks exhibited a high level of professionalism and pride in their company. Daniel Raymond presented himself as knowledgeable and confident as to what Groundworks could help me do. He was very thorough and left me with no doubt that they could fix our problem."
Basement
Basement
Basement
Basement
Foundation

+14

86 neighbors recently requested a quote
Recommended by90%of homeowners
Avatar for Vesta Foundation Solutions
Vesta Foundation Solutions
3.9(
48
)

Serving Garber, OK and surrounding areas

Approved

In business since 2016

Free estimates

Warranties offered

"We used Vesta Foundations for our driveway repair. Mike, Omar, and Rudy did an incredible job and were very professional. They explained the different phrases as they completed each repair which was very helpful. They used a foam to fill in the voids underneath our driveway and also sealed our joints and put a drainage system from our gutters to carry the water on down the side of the driveway."
Concrete Leveling
Response time1 day
99 neighbors recently requested a quote
Recommended by70%of homeowners
...
Showing 1-10 of 60
Masonry questions, answered by experts

The cost to install or replace brick or stone siding generally ranges from $10 to $50 per square foot. The final price depends on several factors, including the specific material type, local labor rates, and any necessary preparation work, such as removing old siding. For example, different types of stone have varying costs per square foot: natural stone ($4.50–$35), stone veneer ($11–$13), faux stone ($6–$9), and cultured or manufactured stone ($5–$8).

Mortar, or masonry mortar, is mainly used in joints and as parging for stone, brick, or cement construction. Stucco is primarily a surface material used as wall coverings. For maintenance, masonry will need repointing or replacing as damage or land shifting occurs, whereas stucco will need patching or refinishing as it tends to crack over time along with other types of wear-and-tear.

You will repoint over a fraction of the old mortar, but you should scrape away 1/2 to 1 inch of mortar from the joints before repointing. Otherwise, the repointing is only masking the weakened mortar instead of actually replacing it, which could put your chimney at risk of bigger, more expensive damages later on.

You can use adhesive strips to hang lights on brick—just make sure you get outdoor mounting tape and not just any old double-sided tape for your project.

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.

The Garber, OK homeowners’ guide to masonry services

From average costs to expert advice, get all the answers you need to get your job done.