Best roofers near El Reno, OK

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Whether you should choose a flat roof or a sloped roof depends on your particular situation. Flat roofs tend to be less expensive to install. However, sloped roofs have longer lifespans and stand up better to heavy snow and other inclement weather.

Keep in mind that even a flat roof needs to have a slight slope, usually around 1/2 inch for every foot. If it is completely flat, water will pool and cause damage, either from weight or leakage or rot.

Generally, hailstones that are one inch in diameter or larger can cause significant damage to a roof. However, smaller hail can also cause damage, particularly when accompanied by strong winds, if it strikes an aging or poorly maintained roof, or if hailstorms are frequent in your area. Hail that is ¼ inch (pea-sized) or smaller poses a minimal risk of immediate, permanent damage, but cumulative impacts can cause deterioration over time. The extent of the damage also depends on the roofing material; hail-resistant tiles like slate or certain types of asphalt shingles can withstand impacts better than other materials. If you are concerned about potential damage after a storm, it is always a good idea to have a professional roofer conduct an inspection.

Yes, an underlayment is required for metal roofs, especially when installed over an indoor residential living space. This underlayment acts as a protective barrier between the metal roofing and the roof deck. Common materials include tar, asphalt felt, or woven synthetic polymers. Depending on local building codes, existing shingles in good condition may also suffice. A quality underlayment is crucial as it provides protection against water intrusion, improves energy efficiency through insulation, helps absorb sound, and ultimately extends the lifespan of your roof.