Get matched with top roofers in Billings, OK

16-gauge galvanized steel staples with a minimum crown of 15/16 inches or 24 millimeters are occasionally used to install shingles. However, most shingle manufacturers or residential building codes don’t recommend staples as a roofing fastener. Roofing nails are preferred in most cases, especially in areas that get a lot of heavy wind.

A roof's ability to handle snow depends on its strength and the snow's weight, as wet snow is much heavier than dry, fluffy snow. While designs in snowy regions often allow for 35 to 50 pounds per square foot, a general guideline is that a typical roof can withstand about four feet of fresh snow, two feet of packed snow, or just one inch of ice. Factors like the roof's age, slope, and support structure also affect its capacity; newer, sloped roofs generally hold more weight than older, flat ones. Ice and ice dams add significant, dangerous weight. Because capacity varies, it is best to contact a professional roofing contractor or the original builder to determine the maximum snow load for your specific home.

A well-maintained tile roof can last anywhere from 40 to over 100 years, with its exact lifespan depending on the material and level of care. Proper maintenance, which includes keeping the roof clean, free of debris, and performing routine repairs for any cracked tiles, is crucial for longevity. The lifespan varies significantly by tile type:

• Clay, terracotta, and slate tiles are highly durable and can last over 100 years.

• Concrete tiles typically last from 30 to 100 years.

• Metal tile roofs generally last between 40 and 70 years.

• Composite tile roofs have a lifespan of 20 to 50 years.

Be aware that maintenance for a tile roof can sometimes be more expensive than for an asphalt roof.

Yes, roof ridge caps are a necessary part of your roof system. Your roof ridge cap is at the peak of your roof, where two slopes of your roof meet. Roof ridge caps seal the seam and help protect your roof from water and debris, and because they’re pre-bent and thicker, they’re more suited to the job than regular roof shingles, which can break when bent.