Best woodworkers near Waterville, OH

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

Some states require carpenters to be licensed to perform forms of carpentry, such as framing. The license requires a certain amount of experience and to pass an examination. In states that don’t require carpenters to be licensed, they must be licensed as a contractor if they work independently rather than solely as a subcontractor under a licensed builder. Use Angi’s contractor licensing tool to find out whether a potential carpenter is licensed in your state.

Whether or not it’s easier to cut wood when it’s wet versus dry depends largely on the type of tool you use and the wood you’re cutting. For example, a chain saw should still be able to cut through wet wood with relative ease, but it may be more difficult to maneuver due to the wood fibers sticking to the chains of the saw. 

However, you might want to avoid cutting wood entirely when it’s wet if you’re pruning your tree. Sawing a wet tree that you don’t plan on removing can also encourage bacterial and fungal growth and decay.

Yes, you can find ceiling joists using simple tools if a stud finder isn't available.

Using a hammer requires patience and a keen ear. Gently tap the ceiling in a grid pattern, listening for sound changes. A hollow sound indicates space between joists, while a solid, dull thud suggests a joist. Mark the location with a pencil and confirm by tapping from different angles.

Alternatively, you can use a nail, but this method will leave small holes. You'll feel increased resistance when the nail hits a joist. Mark the spot and repeat the process every 16 or 24 inches to map the joist locations. This method is considered less reliable than using a stud finder.