Get matched with top electricians in Londonderry, OH

It's recommended that you only use your circuit breaker for your water heater. Tacking on additional appliances, especially large ones like refrigerators, can overload the circuit and lead to electrical fires. Therefore, it's best to have separate circuits for each major appliance, particularly continuous load appliances, which use a lot of energy over prolonged periods of time.

It can be safe to buy or live in a house with knob and tube (K&T) wiring, but only if the system is in good condition, functional, and has been thoroughly inspected and approved by a licensed electrician. Never purchase a home with K&T wiring without getting a professional electrical inspection first.

Key considerations include:

• Safety and Condition: An inspector will verify that the wiring is safe and has not deteriorated. Over time, the insulation can wear away, leaving exposed wires that pose a significant fire or shock hazard.

• System Capacity: The electrical service should be at least 60 amps. However, even at this capacity, K&T systems often struggle to handle the demands of modern appliances and electronics.

• Lack of Grounding: Knob and tube wiring is an ungrounded system, which is a safety concern for many modern devices.

• Ongoing Maintenance: If you live in a home with K&T wiring, it's recommended to have it inspected by an electrician every one to two years to ensure it remains in safe working order.

Ultimately, any inspection or modification of a knob and tube system should always be performed by a certified professional.

Yes, electricians must be licensed, certified, and in most cases, insured. Licensing requirements vary by state and local municipality, but most U.S. municipalities require electricians to hold an electrical contractor’s license. It's always a good practice to confirm requirements with your local municipality. Even if licensing is not required in your area, hiring a licensed and experienced electrician often leads to a better end result.

A license is a legal requirement to operate a business and is necessary for pulling project permits. Certifications, on the other hand, are typically voluntary and demonstrate a certain level of expertise. In some cases, a certified electrician may send an apprentice or journeyman to perform the work, but they must operate under a primary electrician who holds the proper license.

Before hiring, you should verify the electrician's license, insurance coverage, and any third-party certifications. You can use Angi’s contractor licensing search to confirm a pro's license status. Additionally, businesses with the “Angi Approved” badge on our platform meet strict criteria, including having the required state and local licenses, passing a background check, and maintaining a high average rating.

While circuit breakers are designed to be reset after tripping, there isn't a strict countdown to when they will fail. The primary danger lies in a breaker tripping multiple times in a short period without allowing the components to cool down. Theoretically, a standard breaker might handle around 50 trips caused by simple overloading. However, this number can be much lower in practice. For instance, a high-current fault could damage a breaker to the point that it needs replacement after only two resets. Repeatedly resetting a breaker that trips frequently exacerbates the underlying problem by causing the electrical components, wires, and the breaker itself to overheat. This can lead to permanent damage, cause the breaker to trip unnecessarily in the future, and increase the risk of an electrical fire. If a breaker trips every few minutes, you should leave it in the 'off' position and call a qualified electrician for an inspection.