Top-rated drywall insulation pros.

Get matched with top drywall insulation pros in Euclid, OH

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Euclid, OH?

Select your specific project to find the pro for you.

TRUSTED BY EUCLID, OH HOMEOWNERS

  • Average homeowner rating star icon4.5
    Average homeowner rating
  • Verified reviews icon494
    Verified drywall insulation services reviews

Find Drywall insulation pros in Euclid

Avatar for ***** INSTALLED SERVICES INC ***** (440)-339-7023
***** INSTALLED SERVICES INC ***** (440)-339-7023
5.0(
87
)

Serving Euclid, OH and surrounding areas

Approved

In business since 2006

Free estimates

Emergency services offered

"Our large church / school facility required insulation upgrades due to high utility costs and severe gutter icing. We chose Installed Services due to their favorable bid, ability to provide knowledgeable explanation of our insulation issues, and responsiveness to questions / communications. Work was completed in a timely manner. We would likely hire them again if we need further services in the future."
Additional Photos
Additional Photos
Additional Photos
9 neighbors recently requested a quote
Recommended by98%of homeowners
Avatar for United Insulation Company
United Insulation Company
5.0(
17
)

Serving Euclid, OH and surrounding areas

Approved

In business since 2001

Free estimates

Credit card accepted

"United Insulation did a nice job insulating our walls and attic. The work crew was knowledgeable, personable and very neat. When they were done inside the house, you couldn’t tell they were here. It was very important to them to do a good job. The home is quieter, as we live near the Ohio Turnpike. The A/C runs less frequently and the home is comfortable, even during a recent stretch of 90 degrees days. We’re looking forward to the difference during the heating season and will probably update this review in November/December. Overall, we’re thankful we chose Donny and his crew at United Insulation. You should, too."
Set up
All Cleaned up
North Ridgeville
Home Sweet Home
23 neighbors recently requested a quote
Avatar for Primary Home Improvements
Primary Home Improvements
5.0(
27
)

Serving Euclid, OH and surrounding areas

Approved

In business since 2021

Free estimates

Warranties offered

"They arrived on time, it took about 2.5 hours, there is at least 18 inches or more of insulation, and I cannot wait to see the difference in the temperature in the house! Next weekend will be to do blown in insulation in the walls! Many thanks to owner Mike DePasquale and Energy Consultant Kevin Sweeney!"
RetroFoam Injection Foam Insulation
RetroFoam Injection Foam Insulation
Primary Home Improvements Insulation Crew
Primary Home Improvements Insulation Crew
Primary Home Improvements Insulation Crew

+3

Response time10 hrs
Response rate88%
27 neighbors recently requested a quote
Avatar for Koala Insulation of Cleveland West Side
Koala Insulation of Cleveland West Side
5.0(
5
)

Serving Euclid, OH and surrounding areas

Approved

In business since 2024

Free estimates

Warranties offered

Koala Insulation of Cleveland West Side is an insulation contractor dedicated to providing top-notch insulation solutions to residential and commercial properties. We offer fiberglass, cellulose, spray foam, attic ventilation, and other services to create the right solution for your home or business. Our team of certified and experienced professionals prioritizes energy efficiency, comfort, and sustainability, working tirelessly to deliver outstanding insulation services that enhance comfort and efficiency for our neighbors.

Install
Install
Install
Response time2 days
23 neighbors recently requested a quote
Avatar for PURE SEAL INC
PURE SEAL INC
4.7(
27
)

Serving Euclid, OH and surrounding areas

In business since 2004

Credit card accepted

"

Torsten Hansen has the patience of a saint.  As I was considering my options with other companies, I bombarded him with a multitude of questions which he answered thoroughly and in a timely manner.

His price was the best.  



 I have one complaint.  I have a bedroom above an unheated garage.  We removed the old drywall and fiberglass insulation which was riddled with squirrel mess.  We also added air conditioning to the house.  There are heating/air conditioning ducts running at the side of one garage wall and across 3 areas of the garage ceiling. The HVAC contractor said to make sure those were well insulated or humid air would condense on the ducts and damage the new drywall.  I thought that foam would be the best option.

Pure Seal did a really good job of insulating the side vents with high density foam. I had the ceilings and walls done in medium density foam.  But, they left the bottom halves of the ducts across the ceiling unfoamed.  In all but a few spots there was a good 2 inches or more space from the bottom of the vent to the end of the joist.  I measured it . Torsten went out and looked at it from the ground and said there was nothing they could do.  He said if I was worried about condensing water dripping onto the underside of the drywall when the air was on, I could staple some plastic over the areas.  Not a good solution.

 

I tried to foam the vents myself with Great Stuff, but it would not stick to the horizontal surface of the ceiling ducts.  It kept falling off.  So I wound up ripping the vapor barrier off of some fiberglass insulation and tapping it up in the cavity below the ceiling vents.  I then covered the fiberglass with reflectix stapled to the joists.  I told Torsten what I did and he thanked me for taking care of it but stuck by his decision that they could not have done anything.

 

I was disappointed because this was one of the main reasons I wanted foam. 

 



They also cut a wire in trimming the foam but he did offer to pay to fix that. My electrician was doing something else for us so he did not charge us.  That kind of stuff happens and I would not fault him for that but they should have caught it when they inspected their job instead of me having to tell them about it.


"
Applying Spray Foam
Pumping Air Krete
Finishing the Job
Recommended by91%of homeowners
...
Showing 1-10 of 64
Drywall Insulation questions, answered by experts

The tool you use to sand plaster will depend on the size of the project. If you’re just working on a small section of your wall to get rid of an uneven spot on the surface, hand-sanding might work. However, for larger projects, a drywall sander can make a huge difference when it comes to both time and elbow grease—and an orbital sander can help for detailed areas such as around ceiling fans.

A utility knife is sharp enough to score the drywall and it may work in a pinch for outlet box holes. However, one of the best tools for drywall when you need to make exact cuts for an outlet box quickly is a drywall saw. This handheld tool has a longer blade than a utility knife, so it penetrates the thickness of the drywall easily. The design of its handle and the teeth in its blade make it easier to control while cutting quicker than you can with a utility knife.

While not always necessary, you can glue a drywall ceiling in addition to using screws or nails. Drywall is typically secured to ceiling joists with fasteners, which is often sufficient. However, adding construction adhesive can offer benefits like preventing sagging, bridging gaps, and reducing air leaks for better energy efficiency. It may also be used for specific acoustic or insulation needs. On the other hand, many professionals advise against it because properly placed screws make the drywall structural, glue doesn't add strength, and it makes future repairs or replacements significantly more difficult. Ultimately, it's best to follow local building codes and project-specific requirements to decide if adhesive is right for your ceiling.

According to the EPA, mold grows within 24 to 48 hours if left untreated after a water leak. So unless you notice the leak and stop it right away, you only have a day or so before mold is a real concern. If you don’t notice the leak, it can take about three weeks for the mold spores to become visible. That means you’ve likely had an active mold infection for a few weeks by the time you notice discoloration.

The easiest way to remove texture from walls is the soak-and-scrape method. You’ll need to spray a section of the wall with water and let the water soak in and soften the texture. Then, you need to scrape the texture off using a drywall taping knife. This method works best with unpainted walls since paint prevents water from saturating the textured joint compound.

The Euclid, OH homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.