Top-rated drywall insulation pros.

Get matched with top drywall insulation pros in Lyndhurst, OH

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Lyndhurst, OH?

Select your specific project to find the pro for you.

TRUSTED BY LYNDHURST, OH HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon1.4k+
    Verified drywall insulation services reviews

Find Drywall insulation pros in Lyndhurst

Avatar for ***** INSTALLED SERVICES INC ***** (440)-339-7023
***** INSTALLED SERVICES INC ***** (440)-339-7023
5.0(
87
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lyndhurst, OH and surrounding areas

Approved

In business since 2006

Free estimates

Emergency services offered

"Our large church / school facility required insulation upgrades due to high utility costs and severe gutter icing. We chose Installed Services due to their favorable bid, ability to provide knowledgeable explanation of our insulation issues, and responsiveness to questions / communications. Work was completed in a timely manner. We would likely hire them again if we need further services in the future."
Additional Photos
Additional Photos
Additional Photos
12 neighbors recently requested a quote
Recommended by98%of homeowners
Avatar for United Insulation Company
United Insulation Company
5.0(
18
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Lyndhurst, OH and surrounding areas

Approved

In business since 2001

Free estimates

Credit card accepted

"United Insulation did a nice job insulating our walls and attic. The work crew was knowledgeable, personable and very neat. When they were done inside the house, you couldn’t tell they were here. It was very important to them to do a good job. The home is quieter, as we live near the Ohio Turnpike. The A/C runs less frequently and the home is comfortable, even during a recent stretch of 90 degrees days. We’re looking forward to the difference during the heating season and will probably update this review in November/December. Overall, we’re thankful we chose Donny and his crew at United Insulation. You should, too."
Set up
All Cleaned up
North Ridgeville
Home Sweet Home
28 neighbors recently requested a quote
Avatar for Primary Home Improvements
Primary Home Improvements
5.0(
27
)
Blown-In Insulation - Install or Upgrade

Serving Lyndhurst, OH and surrounding areas

Approved

In business since 2021

Free estimates

Warranties offered

"They arrived on time, it took about 2.5 hours, there is at least 18 inches or more of insulation, and I cannot wait to see the difference in the temperature in the house! Next weekend will be to do blown in insulation in the walls! Many thanks to owner Mike DePasquale and Energy Consultant Kevin Sweeney!"
RetroFoam Injection Foam Insulation
RetroFoam Injection Foam Insulation
Primary Home Improvements Insulation Crew
Primary Home Improvements Insulation Crew
Primary Home Improvements Insulation Crew

+3

Response time10 hrs
Response rate88%
27 neighbors recently requested a quote
Avatar for Koala Insulation of Cleveland West Side
Koala Insulation of Cleveland West Side
5.0(
5
)
Blown-In Insulation - Install or Upgrade

Serving Lyndhurst, OH and surrounding areas

Approved

In business since 2024

Free estimates

Warranties offered

Koala Insulation of Cleveland West Side is an insulation contractor dedicated to providing top-notch insulation solutions to residential and commercial properties. We offer fiberglass, cellulose, spray foam, attic ventilation, and other services to create the right solution for your home or business. Our team of certified and experienced professionals prioritizes energy efficiency, comfort, and sustainability, working tirelessly to deliver outstanding insulation services that enhance comfort and efficiency for our neighbors.

Install
Install
Install
Response time2 days
22 neighbors recently requested a quote
Avatar for PURE SEAL INC
PURE SEAL INC
4.7(
27
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lyndhurst, OH and surrounding areas

In business since 2004

Credit card accepted

"

Torsten Hansen has the patience of a saint.  As I was considering my options with other companies, I bombarded him with a multitude of questions which he answered thoroughly and in a timely manner.

His price was the best.  



 I have one complaint.  I have a bedroom above an unheated garage.  We removed the old drywall and fiberglass insulation which was riddled with squirrel mess.  We also added air conditioning to the house.  There are heating/air conditioning ducts running at the side of one garage wall and across 3 areas of the garage ceiling. The HVAC contractor said to make sure those were well insulated or humid air would condense on the ducts and damage the new drywall.  I thought that foam would be the best option.

Pure Seal did a really good job of insulating the side vents with high density foam. I had the ceilings and walls done in medium density foam.  But, they left the bottom halves of the ducts across the ceiling unfoamed.  In all but a few spots there was a good 2 inches or more space from the bottom of the vent to the end of the joist.  I measured it . Torsten went out and looked at it from the ground and said there was nothing they could do.  He said if I was worried about condensing water dripping onto the underside of the drywall when the air was on, I could staple some plastic over the areas.  Not a good solution.

 

I tried to foam the vents myself with Great Stuff, but it would not stick to the horizontal surface of the ceiling ducts.  It kept falling off.  So I wound up ripping the vapor barrier off of some fiberglass insulation and tapping it up in the cavity below the ceiling vents.  I then covered the fiberglass with reflectix stapled to the joists.  I told Torsten what I did and he thanked me for taking care of it but stuck by his decision that they could not have done anything.

 

I was disappointed because this was one of the main reasons I wanted foam. 

 



They also cut a wire in trimming the foam but he did offer to pay to fix that. My electrician was doing something else for us so he did not charge us.  That kind of stuff happens and I would not fault him for that but they should have caught it when they inspected their job instead of me having to tell them about it.


"
Applying Spray Foam
Pumping Air Krete
Finishing the Job
Recommended by91%of homeowners
...
Showing 1-10 of 61
Drywall Insulation questions, answered by experts

There are six levels of drywall finish, from 0 to 5, that refer to the amount of work performed during the finishing process.

Level 0: Drywall is hung with no finishing work.

Level 1: Tape is placed over the seams between drywall sheets.

Level 2: A thin layer of mud is applied over the tape and screw holes. This level is common for utility rooms or walls that will be covered.

Level 3: A full coat of mud covers the screw holes and tape, but the surface is not sanded. This is often used in garages.

Level 4: This is the most common finish for visible interior walls. It involves applying two coats of mud over seams and screw holes, with sanding between each coat, creating a smooth surface ready for flat paint.

Level 5: This is a high-end finish for luxury homes. It includes full taping, mudding, and sanding, plus a final skim coat over the entire surface before painting.

Wall anchors are suitable for drywall and plaster walls, which are common in most homes. However, different wall materials may require specialized anchors. For concrete or masonry walls, you'd typically use concrete anchors. When dealing with other wall types, such as brick or tile, specific anchors designed for those materials may be necessary. Always consult with a hardware specialist or check the manufacturer's recommendations to ensure you select the appropriate anchors for your specific wall type.

If the holes in the plaster are small, you can fill them with layers of patching plaster until they’re filled. After it dries, you can sand the plaster and paint over it. If the hole is much larger, consider using bonding plaster first and then a layer of patching plaster, completing the process with sanding and a layer of paint.

When doing a DIY paint job, it can be tricky to achieve the perfect, straight line between your wall and ceiling. There are several methods, including lining it with painter’s tape and using the “cut in” brush tactic. Some homeowners choose to apply a thin line of caulk to the wall-ceiling seam to create the appearance of a perfect line.

Yes, you can install drywall over plaster, but there are important factors to consider. While it can create a smooth, flat surface, it is often not the best approach. Installing drywall over plaster will increase the wall's thickness, which can cause issues with existing window and door frames that may no longer fit. You might also need to adjust power outlets to keep them accessible. A better, though more expensive, option is to remove the old plaster and lath entirely before installing new drywall. Drywalling directly over plaster seals in the old material, and if any problems arise later, you will need to remove both layers down to the structural beams for repairs. Given the potential complications, this job is best handled by professionals.

The Lyndhurst, OH homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.