Get matched with top dishwasher installation pros in Batavia, OH

Yes, a dishwasher needs an air gap to prevent backflow. Additionally, in many locations, air gaps or another measure to prevent backflow are required for building code compliance. There are alternatives to an air gap, like a Studor vent or a loop and trap design, but an air gap is the simplest and most popular solution.  

A clogged air gap can cause a dishwasher not to drain. There are, however, other potential issues that can lead to improper drainage. For example, if you have attached the air gap to a garbage disposal and forgotten to remove the knockout plug, wastewater may backflow into the dishwasher. Check that the air gap is installed properly, and then look for clogs in the air gap and dishwasher filters. 

To get rid of standing water in your dishwasher, first try activating the drain mechanism by pressing and holding the cancel button for at least three seconds. If that doesn’t work, you’ll need to do some troubleshooting to drain the standing water from the dishwasher. This will involve shutting off the power, then scooping out the water, cleaning the drain filter, and clearing the air gap. You’ll also want to run the garbage disposal and check the drain hose for clogs.

Your dishwasher drains through a hose that attaches to the plumbing below your sink or snakes out the back of your machine. In most cases, you can access one side of the hose from below your sink, as it usually ties into the same drainline that your sink uses. Otherwise, you may need to pull the dishwasher out of the counter to access it.