Best roofers near Alexandria, OH

The lifespan of a torch down roof depends on the number of layers installed. A single-ply system typically lasts between 10 and 15 years, while a multi-layer system with two or three layers can last from 15 to 25 years. Although a multi-layer option may be more expensive upfront, it provides a longer service life. Warranties often reflect this, with about 12 years for a one-ply system and 15 years for a two-ply system. For context, this lifespan is shorter than other common roofing materials like wood or asphalt shingles, which typically last 20 to 30 years, with high-quality versions lasting up to 50 years.

Asphalt shingles blister when air gets trapped between building materials, either within the layers of the shingle itself or in adhesives on the undersides of the shingles. As the roof heats up in direct sunlight, the trapped gas expands and creates a bubble in the roof. Eventually, the bubble can pop, leaving an exposed area of decking and underlayment.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Yes, it’s possible to replace drip edge flashing without removing shingles, but it’s not a good idea. You’ll have to lift the bottom shingles up to remove the old drip edge, install the new material, and then lay the lifted roofing material over the new drip edge. Bending roof shingles can cause damage, and if you have ongoing issues with roof leaks that prompt drip edge replacement, it’s a good idea to consider a roof and drip edge replacement to avoid ongoing issues.