Get matched with top epoxy flooring pros in Elko, NV

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

Yes, professionals offer slip-resistant options for added workplace safety.

Spills like water, oil, or grease can wear down the epoxy's strength, lowering its lifespan. While this damage doesn’t happen immediately, it can accumulate over time, so cleaning up any garage spills as soon as they happen is essential. Avoid cleaning with or using dish soap on your epoxy floors since they will leave an unattractive residue. Instead, you can use half of a cup of ammonia diluted with a gallon of water for cleaning purposes.

If your garage floor is heavily soiled or stained, then it’s a good idea to powerwash it with a concrete cleaner before sealing. This process will remove dirt and debris to help the new sealer bond to the concrete properly, and it will also improve the look of your sealed garage floor. After power washing your floor, make sure you let the concrete dry completely before applying sealant, usually for 24 to 48 hours.