Top-rated concrete driveway pros.

Get matched with top concrete driveway pros in Elko, NV

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete driveway service project in Elko, NV?

Select your specific project to find the pro for you.

Find Concrete driveway pros in Elko

Arford's Handyman Services
New to Angi
Asphalt Paving - Install

Serving Elko, NV and surrounding areas

In business since 2019

Free estimates

Emergency services offered

Arford's Handyman Services is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.

Concrete Driveways questions, answered by experts

Yes, you can pressure wash with just water. The force of the water alone is often enough to remove dirt, grime, and debris from many surfaces. However, for tougher stains like grease, mildew, or algae, adding a detergent or cleaning solution can enhance the cleaning power. Be sure to use the appropriate nozzle and pressure settings for the surface to achieve the best results without causing damage.

When comparing installation costs, asphalt is often less expensive upfront than concrete. Asphalt prices typically range from $7 to $15 per square foot, while concrete can range from $3 to $18 per square foot. However, long-term costs should also be considered. Concrete driveways generally last longer (up to twice as long) and require less maintenance, which can make them more affordable over their lifespan. While asphalt has a lower installation cost and is easier to repair, it requires more frequent maintenance, such as sealing, which can add up over time. Therefore, while concrete is more expensive initially, its durability may offset the cost in the long run.

Annually, or more if located in humid or heavily polluted areas.

Always begin by removing large debris, leaves, and branches from your lawn to make room for the rest of your lawn maintenance checklist. Move on to mowing, weeding, and edging in the spaces between your lawn and garden. Lastly, clean off all hardscapes, porches, and patios for a fresh and tidy appearance.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

The Elko, NV homeowners’ guide to concrete driveway services

From average costs to expert advice, get all the answers you need to get your job done.