Top-rated floor sanding pros.

Get matched with top floor sanding pros in Silver City, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your floor sanding project in Silver City, NM?

Select your specific project to find the pro for you.

Find Floor sanding pros in Silver City

D & R Services
4.6(
47
)

Serving Silver City, NM and surrounding areas

In business since 2010

Free estimates

Emergency services offered

"Contractor keep appointment (even though there were 2 or 3 calls expressing confusion about time and day); installed the drywall and cleaned the area.   The drywall installation was not smooth and when textured looked amateurish at best.  Before I could paint I had to sand several areas and apply canned texture-not the most professional look but time was a factor.  the next time the wall is painted will require extensive prep work to make it look professional.
Good things: appointment keep; work was done as explained; no extra charges.
Not so good: Technician was not a drywall guy.
"
Additional Photos
stamped concrete and curb
stamped concrete and curb
stamped concrete and curb
tile

+107

Recommended by82%of homeowners
Floor Sanding questions, answered by experts

Permit requirements to clear land vary by municipality, so whether or not you need permits depends on where you live and what you’re removing from the land. Some building departments will require permits for any underground work or excavation, meaning grinding down tree stumps on your property would require permits. Others mandate individual permits for each tree you remove. You can contact your local building department or a land-clearing specialist near you to see if permits are necessary for your job.

Measure from zero on a measuring tape by placing the metal hook right up against the edge of what you need to measure. You can also latch the hook onto an open edge—of, say, a table—to accurately measure as well. If you begin at the 1-inch mark, you'll need to subtract an inch from your total.

Property lines, building locations, and potential encroachments are mapped.

Costs vary, but you can expect to spend between $1,000 and $4,000 to prepare land for a mobile home or before you build a house. You’ll need to clear enough land for the foundation, which may require leveling or grading, as well as removing trees, stumps, and plants. Don’t forget to plan for permits and fees and the installation of a gas line, water line, and sewer main.

Building a road on a slope requires careful planning and will normally require a drainage system underneath to prevent flooding and damage to the road over time. Your professional may lengthen your road to create switchbacks if the slope directly to your home is too steep, as there are regulations for maximum road slope. The drainage system will help prevent runoff from the higher side of the slope from damaging the asphalt or concrete. Keep in mind that building a road on a slope isn’t a good DIY project, as a lot can go wrong.

The Silver City, NM homeowners’ guide to floor sanding services

From average costs to expert advice, get all the answers you need to get your job done.