Get matched with top concrete resurfacing pros in Ruidoso, NM

Concrete resurfacing and concrete overlay are terms often used interchangeably to describe the process of applying a new, thin layer of pre-blended concrete over an existing slab. This process enhances the durability and appearance of the concrete, giving it a fresh look without the high cost of a full replacement. The new layer is typically between 1/4-inch and 1-inch thick, significantly less than the 4 inches required for a new slab, and can be stamped, colored, or textured for a custom finish.

While the terms are often considered the same, their meaning can sometimes vary by contractor. Some may use "overlay" to describe a thicker application that adds structural integrity, while "resurfacing" might refer to a thinner layer intended for cosmetic upgrades. Other common names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.

Mix the resurfacer into a sticky mixture. The consistency should look like mashed potatoes. Use a squeegee to push the resurfacer across the pitted area and smoothen the surface with a cement trowel flush. Make sure you protect any expansion joints with a weather strip. Alternatively, cut out any resurfacer that touched the joint once the mixture begins to harden.

While a contractor is on-site repairing your concrete steps, you can have them inspect other concrete surfaces for minor damage. They may be able to fix cracks in your driveway or garage floor during the same visit. You can also ask them to check your home's foundation for minor issues they can address. However, general concrete repair experts typically cannot handle larger jobs, like leveling a sunken foundation. For major structural projects, you will need to hire a structural engineer.

Most projects take 1-3 days, though curing times may require additional downtime.