Top-rated structural engineers.

Get matched with top structural engineers in Radium Springs, NM

Enter your ZIP and get matched with up to 5 pros

Need a pro for your structural engineering project in Radium Springs, NM?

Select your specific project to find the pro for you.

Find Structural engineers in Radium Springs

Quality Elevators & Lifts

5.00(
1
)

Quality Elevators & Lifts

5.00(
1
)
Customers say: Quick response
Recommended by 100% of Angi customers
Recommended by 100% of HomeAdvisor customers

Quality Elevators & Lifts is a Local independent company providing sales, installation, service, repair & re-modernization for your residential or commercial elevators & lifts.

Quality Elevators & Lifts is a Local independent company providing sales, installation, service, repair & re-modernization for your residential or commercial elevators & lifts.



Badlands Inc. Construction & Roofing

1.00(
1
)

Badlands Inc. Construction & Roofing

1.00(
1
)
29 years of experience

No Sub-Contracting our crew does the work! Business built on entegrity and reliability! We donate a portion of "your" work performed to the St. Judes cancer society for children. "You're in Good Hands with Badlands"!

No Sub-Contracting our crew does the work! Business built on entegrity and reliability! We donate a portion of "your" work performed to the St. Judes cancer society for children. "You're in Good Hands with Badlands"!

Structural Engineering questions, answered by experts

Yes, you can put a doorway in a structural wall; in fact, most exterior doors are set into structural walls. The project is a little more challenging than installing a door in a non-load-bearing wall because you need a structural engineer to assess the wall and make sure it’s safe to create a wall opening. Your engineer’s report will include instructions for your contractor on how and where to install additional supports, like steel headers above the door, to distribute the weight above to the wall on either side of the door.

Clean regularly, treat wood for weather resistance, and inspect for damage to ensure longevity.

Generally, you can tell if a home is bolted to the foundation by checking the foundation for plates. If you see that your foundational plates connect to wood or bolts protruding from them, this means that you have a bolted foundation. However, it's always wise to bring a home inspector in to confirm if your foundation is secure.

Water can seep into porous materials like wood beams, floor joists, and roof rafters within minutes, but they’ll need to see prolonged exposure before you have structural damage. Mold can start growing within 24 hours, and mold can eat away at the structural components over time. Wood rot is more of a concern, though. Wet and dry rot are fungal infections that set in in moist conditions and rapidly deteriorate wood, causing major structural damage within just a few months in some cases.

The 10 10 rule describes the formula most contractors use to determine how much to charge for a job. Allowing for 10% overhead above the total projected cost to do the work and 10% profit sets a contractor up for success, even if there are delays or other problems on the project. This formula isn’t a hard-and-fast rule, but it is a ballpark figure to begin with when estimating your expenses on a job.

The Radium Springs, NM homeowners’ guide to structural engineering services

From average costs to expert advice, get all the answers you need to get your job done.