Permian H2O Solutions, LLC is a licensed and insured water well drilling and service company. We pride ourselves on great service and pricing. Most service call are taken care of the same day. Permian H2O Solutions has been in business for 5 years serving the Permian Basin. We service a 150 mile around Midland/Odessa.
"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
There are many reasons you may want to extend the depth of an existing well or drill a new, deeper well on your property. A deeper well can tap cleaner water sources—shallow water may contain more contaminants. With a deeper well, you’ll also have an easier time reaching the water table depth (the level at which underground water is found) and can get past tricky soil conditions.
Plus, if your local building code requires a minimum well depth for safety and environmental standards, you’ll meet the code by digging a deeper well in the first place.
If your well pump is running continuously (meaning without turning off or stopping), it's a sign that your well pump is starting to break down. The length of time your well pump should cycle is dependent on many factors, like the tank size, pressure setting, and even the amount of water in your well. Generally, your well pump should cycle, or go from running to not running every few minutes.
The cost to fix low water pressure heavily depends on the cause of the problem. In some cases, all you need to do is open a valve, which won't cost you anything. However, plumbing repairs cost an average of $325, so if you have a broken pipe or other plumbing problems, you might pay something close to that figure, or more, depending on the issue.
A sprinkler pump may not turn on because of problems with the power supply or the circuit breaker. It can also stop working if the motor burns out. If it’s not a tripped breaker, a burned-out motor, or another issue with the power, it’s time to call in a sprinkler repair pro to take a closer look.
Consider replacement if the pump is over 10 years old or has recurring, costly issues.
The Loving, NM homeowners’ guide to well and pump services
From average costs to expert advice, get all the answers you need to get your job done.
If you have a well, you might need to replace the well pump to have great-tasting water. Well pump replacement costs depend on your well size and other factors.
When your water system isn’t working as intended, it’s time to repair your well pump. This cost guide will break down well pump repair costs and the parts involved.
The four types of well pumps are submersible, jet, centrifugal, and hand pump. Choose the appropriate one based on the depth and size of your property’s well.
Well pumps require electricity to operate and can affect your monthly bill. Learn about the factors that impact the average cost to run a well pump per month.
The right well pump will give you consistent water pressure and flow to your home. Learn about well pump types and how to choose what size well pump you need.