Top-rated well and pump technicians.

Best well and pump technicians near Crownpoint, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Crownpoint, NM?

Select your specific project to find the pro for you.

Top-Rated Well and pump technicians in Crownpoint - Updated Nov 2026

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Crownpoint, NM and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Request Quote
Wells and Pumps FAQs, answered by experts

If your water pump fails, the first step is to turn off the power to the pump to prevent any further damage. Check for common issues such as clogs, electrical problems, or mechanical failures. If you cannot identify the problem, contact a professional who specializes in pump repairs. Prompt action can help minimize damage and repair costs.

There are many signs to look for that will tell you when your irrigation pump is burned out. This may include low water pressure, sprinklers that sputter a lot before turning on, discolored or dirty water, or a pump that stops working altogether. If your pump has any of these issues, it is probably time to replace it.

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

No. Well pump replacement is not recommended as a DIY project, particularly if you have a deep well and a submersible pump. Plumbing and electricity are best left to the pros, especially when something like your well pump includes both. Even when troubleshooting your pump, it pays to have a partner standing by for your assistance and safety.

Why is my irrigation pump not pulling water?

There are a few reasons your irrigation pump isn’t pulling in water. You could have a clogged suction filter. You may have not properly primed your pump so air got stuck somewhere in the system. Your pump also won’t work properly if it has faulty or damaged pump components, like a pump motor or pressure switch.

The Crownpoint, NM homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles