"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Every 1-2 years to ensure optimal performance and prolong lifespan.
You should check water pressure twice a year to ensure there aren’t any irregularities and that it isn’t too high. It’s also smart to check it any time you notice symptoms of high water pressure (like banging pipes, inconsistent water flow, and leaky fixtures). Similarly, if you live in an area that’s prone to water pressure fluctuations due to municipal supply changes, elevation, or seasonal temperature shifts, check it more frequently. You can buy an affordable water pressure gauge and check the water pressure yourself.
There are other ways to increase well water pressure. You can often increase the pressure by adjusting the valve on your pressure tank. The pressure issue may be the result of build-up along the pipes or a clog in the system, so descaling and unclogging your system can help improve the overall pressure.
The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.
For example:
If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.
If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.
Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.
Yes, you can shock a well yourself, but it can be dangerous if you don’t know what you’re doing. We recommend calling a pro, but if you decide to do it yourself, make sure to follow proper safety precautions. This means wearing the correct safety gear, such as rubber gloves, goggles, and boots. You should also mix the chlorine solution in an open area with plenty of ventilation. Also, make sure not to drink or use the water for a few days afterward, until you’ve flushed the system and retested the water.
The Yah-ta-hey, NM homeowners’ guide to well and pump services
From average costs to expert advice, get all the answers you need to get your job done.
If you have a well, you might need to replace the well pump to have great-tasting water. Well pump replacement costs depend on your well size and other factors.
When your water system isn’t working as intended, it’s time to repair your well pump. This cost guide will break down well pump repair costs and the parts involved.
The four types of well pumps are submersible, jet, centrifugal, and hand pump. Choose the appropriate one based on the depth and size of your property’s well.
Well pumps require electricity to operate and can affect your monthly bill. Learn about the factors that impact the average cost to run a well pump per month.
The right well pump will give you consistent water pressure and flow to your home. Learn about well pump types and how to choose what size well pump you need.
