"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Precision Service Plumbing & Heating is experienced in all aspects of plumbing. We pride ourselves on our customer relations and repeat business. We look forward to working with you.
You should check water pressure twice a year to ensure there aren’t any irregularities and that it isn’t too high. It’s also smart to check it any time you notice symptoms of high water pressure (like banging pipes, inconsistent water flow, and leaky fixtures). Similarly, if you live in an area that’s prone to water pressure fluctuations due to municipal supply changes, elevation, or seasonal temperature shifts, check it more frequently. You can buy an affordable water pressure gauge and check the water pressure yourself.
If you notice that your well pump runs continuously, it’s important to take action quickly to avoid further damage. A few common issues may be to blame for a continuously running well pump, such as mechanical damage, a faulty pressure control switch, low water level, prime loss, and leaking pipes and fixtures.
Most professionals recommend that a deep well pump shouldn’t run more than 10 hours consecutively before cycling off. Overworking the well pump beyond the recommended amount can prematurely wear out your pump and burn out the motor, which means replacing it more often than you otherwise should need to. Your well pump should also come with the manufacturer’s use and maintenance recommendations that are specific to the model.
The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.
For example:
If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.
If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.
Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.
If your water pump fails, the first step is to turn off the power to the pump to prevent any further damage. Check for common issues such as clogs, electrical problems, or mechanical failures. If you cannot identify the problem, contact a professional who specializes in pump repairs. Prompt action can help minimize damage and repair costs.
The Paguate, NM homeowners’ guide to well and pump services
From average costs to expert advice, get all the answers you need to get your job done.
The four types of well pumps are submersible, jet, centrifugal, and hand pump. Choose the appropriate one based on the depth and size of your property’s well.
Well pumps require electricity to operate and can affect your monthly bill. Learn about the factors that impact the average cost to run a well pump per month.
The right well pump will give you consistent water pressure and flow to your home. Learn about well pump types and how to choose what size well pump you need.
