Top-rated epoxy flooring pros.

Get matched with top epoxy flooring pros in Cannon Air Force Base, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your epoxy flooring service project in Cannon Air Force Base, NM?

Select your specific project to find the pro for you.

Find Epoxy flooring pros in Cannon Air Force Base

Avatar for Mammoth Coatings
Mammoth Coatings
4.2(
5
)
Concrete Floor Coating-Apply - For Business

Serving Cannon Air Force Base, NM and surrounding areas

In business since 2018

Free estimates

Credit card accepted

"I hired this company to resurface my 3 car garage. I was shocked to find I could have a glossy design for my budget... instead of just having my concrete fixed up. Thank you Mammoth!"
Einstein Bros Bagels
Chips
Garage Floor with Chips
Chips
Joint Fill

+6

Response time2 days
Response rate89%
Recommended by100%of homeowners
Avatar for Villanueva Concrete
Villanueva Concrete
5.0(
4
)
Concrete Finishing, Overlays & Coloring - Apply

Serving Cannon Air Force Base, NM and surrounding areas

In business since 2017

Free estimates

Emergency services offered

"A very good experience. Dominic and his crew worked on this project until we and they were satisfied. They went above and beyond. We have already recommended them and will definitely keep them in mind for future projects."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+17

Response time2 days
Recommended by100%of homeowners
Showing 1-10 of 12
Epoxy Flooring questions, answered by experts

No. You cannot use asphalt products on concrete driveways. To seal a concrete driveway, use acrylic, epoxy, polyurethane, silane, siloxane, and silicate sealers or deep penetration sealers made specifically for concrete. Meanwhile, asphalt sealers contain refined coal tar (asphalt emulsion), water, sand, clay, polymers, and additives and are incompatible with concrete’s surface texture and higher density.

Driveway installation is challenging. While chip seal might sound easier to apply than asphalt, the process still involves heavy machinery and professional skills. Unless you come from a construction background, we recommend hiring an asphalt company to chip seal your new driveway. If you are paving the driveway entirely with chip seal, expect to pay $5 to $10 per square foot.

You can’t paint a foundation like you would the walls in your home; there are a few extra important steps to take. Instead of just busting out the paint, you should clean the surface and fix any impurities before grabbing the brush. Using a paint sprayer to apply sealant and primer will ensure you have the perfect canvas to apply your chosen paint color.

Most coatings take 1-3 days, including surface preparation and drying time.

Resurfacing a garage floor takes about eight hours on average, with another couple hours over three days to do the epoxy. Epoxy goes on in three coats, with each coat taking 24 hours to dry and cure. You’ll need to keep foot and vehicle traffic off of your garage floor for around 4 days in total when replacing your garage floor, so be sure to plan ahead before you start. This is a great time to organize your garage since you’ll need to move everything out to apply the epoxy.

The Cannon Air Force Base, NM homeowners’ guide to epoxy flooring services

From average costs to expert advice, get all the answers you need to get your job done.