Get matched with top electricians in Three Bridges, NJ

How far you can run underground electric depends on the wire gauge (generally AWG) and the circuit voltage. Too much voltage drop in an electrical circuit can negatively affect performance, so the smaller the voltage drop, the better. Ideally, it shouldn't exceed 3%. The smaller the wire and the longer the run, the more significant the voltage drop. 

For example, with a 120-volt circuit, you can run 60 feet of 12 AWG cable without losing more than 3% voltage. With a 240-volt circuit, you can run 120 feet of 12 AWG wire while maintaining a voltage drop of 3% or less.

It’s important to ask an electrician a few questions before you commit to hiring them so you can make an informed decision as a consumer. If you’re getting estimates or considering hiring an electrician, ask them these questions:

• Are you a full-time electrician?

• Are you bonded, licensed, and insured?

• What level of experience do you have as an electrician?

• Can you please share three references?

• Do you do residential or commercial electrical work?

• What kinds of electrical work are you most familiar with?

• Will any subcontractors be performing the work?

• Are permits and inspections required?

• Who is responsible for obtaining permits and inspections?

• What is your schedule?

• Do you offer a guarantee or warranty on your work?

• Will you sign a do-not-exceed clause to keep the job within the budget?

The average radon mitigation system uses about 876 kWh of electricity per year, although the exact amount of electricity used will vary depending on the size of the radon fan. Once the system is installed, the annual increase to your energy bill could range from $30 to $300 per year, again depending on the size of the fan.

To install an outlet from existing wiring, you’ll need to choose a location where you can already access existing wiring. The easiest way to do this is to install an outlet on the other side of the wall of an existing outlet. 

Since the wiring is already in place, all you have to do is connect a new cable to the existing wiring and then connect the correct wires through the wall—to the new electrical outlet. Place your new outlet into the opening in the wall and then connect the correct wires to the appropriate terminal screws.